Monarch Mobility ATLAS4 User manual

ATLAS4 CAR BOOT HOIST GUIDE

The Atlas4 hoist is designed to fit a range of cars and has a lifting capacity
of up to 40kg and under no circumstances should the hoist system be made
to exceed this weight limit. Subjecting the lift system to the strain of lifting
more than it is designed to may cause it to fail.
This guide is designed to provide advice for selecting the correct vehicle,
wheelchair and scooter, assembly and fitting.
The Atlas4 is portable and easy to assemble which allow the
user to take the Atlas4 away on holiday or use in
multiple of cars.
ATLAS4 HOIST
KEY SAFETY POINTS
• Maximum load capacity 40kg
• Automatic Up and Down
• Swinging boom
• Folding and removable boom
• Hoist can either be fixed or removed
• Multiple power options
• Remote Control option
• Parcel Shelf can be used
• Easy Vehicle transfer
• WARNING! The Atlas4 must never be operated by a child or any
person not deemed appropriate to operate the equipment.
• WARNING! The Atlas4 should always be fully secured before
operating.
• WARNING! Never use a system that shows signs of damage.
• WARNING! Do not exceed maximum loading capacity.
• WARNING! Misuse of the Atlas4 may result in serious injury.

COMPONENT
DESCRIPTION
ASSEMBLY
BOOM ARM
BOOM BASE
UP & DOWN
BUTTON
POWER CABLE PORTABLE POWER PACK
ADDITIONAL EXTRA
BOLTS & ALLEN
KEY
LIFTING STRAP &
HOOK
SUPPORTING
BAR
HEIGHT LOCATING
SLOTS
RATCHET &
RATCHET LEVER
SECURING BAR
RELEASE &
SECURING CATCH
Lay all parts on the floor
Connect the Supporting bar
to the Securing bar
Using the 4 bolts supplied secure
the boom base to the securing bar with
the supplied Allen key
Place the boom base on top of the
securing bar ensuring that the bolt
holes are in line

FITTING OPERATION
TROUBLESHOOTING
• Place the frame into the boot with the boom
base situated to the left of the boot lip and the
Supporting bar is running left to right alongside
the inside of the boot lip
• Using the ratchet lever, ratchet the hoist frame against the rear seat and boot lip until
the frame is fully secured.
• Insert the boom arm into the boom base ensure that the securing catch is lifted, then
released once the boom arm is secured firmly.
• See Operation instructions
• Connect and secure power cable to the
boom
1. Swing the boom arm outwards to its outmost position.
2. Ensure the scooter is positioned in the correct position for lifting.
3. Press & hold the down button to lower the hoist
4. Connect the lifting hook securely to the scooter.
5. Press and hold the up button to raise the scooter above the boot lid, steadying the scooter to
ensure it does not contact the vehicle.
6. Carefully swing the boom inwards into the boot.
7. Press & hold the down button to lower the hoist until the scooter is firmly placed on the vehicle
floor.
8. Remove lifting hook from the scooter.
9. Press and hold the up button to retract the hoist lifting strap and hook.
10. Disconnect the power supply.
11. Lower the boom arm and remove from the boom base by lifting on the release and secure catch.
12. Stow away the boom arm securely and close the boot.
No power Check that the power cable is securely connect to both
the hoist and power supply.
Stops during lifting Is the scooter caught on the vehicle?
Hoist is lifting very slow Is the scooter too heavy for the hoist?
Is the power supply charged suciently?