
EN - 9
2. INSTALLATION
• Before contacting the local Authorised
Service Provider for the installation
of the dryer, check the information in
the user manual to make sure that the
electrical installation and water outlet is
suitable. If they are not, call a qualied
electrician and a plumber to have the
necessary adjustments made.
• It is the customer’s responsibility to
prepare the dryer’s installation place, as
well as the electricity and waste water
installation. Before installation, check
the dryer for damage. If damaged, do
not have it installed. Damaged products
may endanger your health.
•Install the dryer on a stable and at
surface.
• Run the dryer in a dust-free
environment where the air ventilation
is good.
• The clearance between the dryer and
the oor should not be reduced with
objects such as carpets, wood or tape.
•Do not block the ventilation grills
found on the plinth of the tumble dryer.
• The appliance must not be installed
behind a lockable door, a sliding door
or a door with a hinge on the opposite
side of the tumble dryer, in such a
way that blocks the full opening of the
tumble dryer door.
• Once the dryer has been installed, the
connections must remain stable. When
installing the dryer, make sure that the
rear surface is not leaning on anything
(e.g. tap, socket).
• The operating temperature of the dryer
is +5°C to +35°C. If operated out of this
temperature range, the performance of
the dryer will be aected negatively and
the product will be damaged.
• Be careful when carrying the product
since it is heavy. Always wear safety
gloves.
• Always install the product should be
placed against a wall.
• The rear surface of the product should
be placed against the wall.
• When the product is placed on a stable
surface, use a water level to check if it
is fully stable. If not, adjust the feet until
it becomes steady. Repeat this process
every time you relocate the product.
• Do not place the dryer onto the power
cable.
ATTENTION: The hose must be
connected in a manner that it cannot be
displaced. If the hose comes out during water
discharge, there might be ooding in your
house.
IMPORTANT:The water discharge
house must be installed at a height of 80 cm
maximum.
IMPORTANT: The water discharge hose
must not be bent between the outlet and the
product, folded or stepped over.
2
1
3
2.1. Connection to Water Outlet (with
optional drain hose)
In products with a condenser unit, water
accumulates in the water tank during the
drying process. You must empty the
accumulated water after each drying process.
Instead of periodically emptying the
water tank, you can also use a water drain
hose which can be purchased as an
optional extra to directly drain the water
outside.
1. Pull and take out the end of the hose at the
back of the dryer. Do not use any tools to take
out the hose.
2. Fit one end of the water discharge hose, to the
slot from which you have removed the hose.
3. Fix the other end of the water discharge hose
directly to the water outlet or sink.