6. Mode Switch:
7. COLOR Knob: Adjust the feedback of flanger.
Note: Setting the COLOR knob at its most clockwise point could
cause an oscillator noise tone, this is normal, use this special
sound to create unique effects!
8. RANGE Knob: Adjust the limit range of sweeping scope in Normal
mode and manually adjust the filter matrix in Filter mode.
The sweeping range will get larger when clockwise turning.
9. RATE Knob: Adjust the speed of flanger in Normal mode.
It will be disengaged in Filter mode.
Switch between Normal mode and Filter mode.
Classic analog flanger sound with filter mode and oscillator effects
2 Working Modes: Normal/Filter
Full metal shell
Very small and exquisite
True bypass
DC 9V Adapter power supply
Main Features
Analog Flanger Pedal 1. TRUE BYPASS
Push down the footswitch
to switch between effects
and bypass status.
2. ON/OFF LED:
Instructs effects or bypass
status of Eleclady, when
the LED is lit up, the effects
is on.
3. DC IN Power Jack:
For power supply, use a 9-volt
DC regulated AC adapter(plug
polarity is positive on the barrel
and negative in the center).
4. INPUT Jack:
1/4” mono audio jack, for
connecting guitar.
5. OUTPUT Jack:
1/4” mono audio jack, outputs
the signal.
Footswitch:
4
5
7
Normal: Normal flanger mode, undulating electricity sound.
Filter: Freeze the flanging effect, create a static filter sound.
9
3
6
8
Working Modes: 2
Input: 1/4” monaural jack (impedance: 1M )
Output: 1/4” monaural jack (impedance: 510 Ohms)
Power Requirements: AC adapter 9V DC (center minus plug)
Current Draw: 10 mA
Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)
Weight:160g
Accessories: Owner’s Manual
(Normal, Filter)
Ohms
* Disclaimer: Any specification’s update won't be amended in this manual.
