Mooer TresCab Setup guide

6. LOW/DIS. Knob:
9. CAB Models Knob: Select different cab simulation mode.
1. TRUE BYPASS Footswitch:
Push down the footswitch to toggle
between on and bypass status.
2. ON/OFF LED:
3. DC IN Power Jack:
For power supply, use a 9-volt
DC regulated AC adapter (plug
polarity is positive on the barrel
and negative in the center).
4. INPUT Jack:
1/4” mono audio jack, for connecting
guitar.
5. OUTPUT Jack:
1/4” mono audio jack, outputs the signal.
* Disclaimer: Any specification’s update won't be amended in this manual.
7. Mode Switch: Choose the EQ or MIC.
Shows the on/off status of TresCab,
when the LED is lit the
effect is engaged.
Main Features
Ca b Simulated Pedal
High-quality digital Cab simulated pedal, offers five different types
of cab choices
Can select two-stall balanced adjustment and microphone pick up
location selection with the mode switch
Adjusts low frequency in EQ mode;
adjusts the distance between
microphone pickup and cabinet in
CAB mode.
8. HIGH/POS. Knob: Adjusts hi frequency in EQ mode; adjusts the deviation
of center position between the microphone and cab pickup.
Cab Models: 1x8 Combo/1x10 Combo/1x12 Open/2x12 Open/4x12 Close
Input: 1/4” monaural jack (impedance: 470k Ohms)
Output: 1/4” monaural jack (impedance: 100 Ohms)
Power Requirements: AC adapter 9V DC (center minus plug),
recommended to use Mooer Micro Power
Current Draw: 128 mA
Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)
Weight: 150g
Accessories: Owner’s Manual
5
94
8
3
6
7
Full metal shell
Very small and compact design
True bypass switch
DC 9V adapter power supply