
3
Brugermanual
Moonboon slyngevugge 3
User Manual
Mosquito Net
6
7
Assembly
Locate the Mosquito Net’s overlapping opening – this is the front of the
product.
Locate the top of the mosquito net where the drawstrings are. If the draw-
strings are tied, untie them. Widen the opening at the top as much as possi-
ble. When widening the opening, make sure the drawstrings are not pulled
into the drawstring tube.
Pull the Mosquito Net up around the Cradle, Baby Hammock or Twin Baby
Hammock through the top opening.
Adjust the net to ensure the overlapping opening is aligned to the front of the
Cradle, Baby Hammock or Twin Baby Hammock, where the Moonboon
logo is shown.
If installing the Mosquito Net on a Baby Hammock or Cradle, use the snap
button to attach the Mosquito Net to the metal ring. The button fastening
goes inside the metal ring.
If installing the Mosquito net on the Twin Baby Hammock, the snap button
fastening is attached through both of the two triangle carabiners.
Once the button fastening is secured, tighten the drawstrings and tie them
together it in a loose double knot. For safety reasons, ensure that the length of
this and any remaining drawstrings stay short, so that your baby cannot reach
them.
Your baby is now ready to enjoy a peaceful nap, undisturbed by insects.
2
1
3
4
5
If you are using a Moonboon Motor,
leave space around the motorwire
string when tightening the drawstrings
to avoid any interference.
Please note
Do not tie the double knot too tightly.
This will allow you to easily untie the
knot to remove the net again easily.
Please note