More BYO Manual

Step 1.
Locate the NBN Connection Box that has been installed inside your property.
Step 2.
Gently lift the cover of the NBN Connection Box. To do this press the two clips
on either side and lift the cover at an angle.
BYO ROUTER SETUP
FTTP CONNECTIONS

Step 3.
Ensure that the power cable is securely in place and that the Power and Optical
lights are showing as steady green on the Connection Box.
Step 4.
Now look on the under side of the NBN Connection Box where you can see the
Uni-D ports surrounded by yellow.
Using an ethernet network cable connect your router from its WAN port to the
relevant Uni-D port on the NBN Connection Box. We generally activate the next
available Uni-D port –starting with Uni-D 1. We will detail your Uni-D port number
in our emails to you.
Step 5.
Connect a computer or laptop to your BYO router via a cable or by WIFI and
access the router configuration page. If you are unsure how to do this, please
consult the router user guide.
Step 6.
Most routers will provide a Quick Start Guide or Setup Wizard –please try and
follow these steps. Ensure that your router is configured in WAN mode and
encapsulation is set to PPPoE. On most devices you should leave all other

settings as default. Then configure your BYO router using the ISP username and
password that we will have emailed and SMS’d to you.
Due to the number of router brands available it is hard to give precise setup
information here. We recommend consulting your router user guide or speaking to
the manufacturer of your device.
Step 7.
After you have successfully configured your BYO router please wait a couple of
minutes for it to connect to the network. After a couple of minutes you should
see the authentication light on the router become lit and steady (not flashing).
The authentication light is often labelled ‘Internet’ or ‘www’ or ‘Web’. Please
consult your router user guide if you are unsure which light is the authentication
light.
TROUBLESHOOTING
Symptom
Things to try
Optical light on the
NBN box is red
1. You will need to contact our team in this instance, and we
may need to log a fault with NBN.
www or internet light
does not come on
1. Ensure that the router has been correctly configured with the
ISP username and password. Triple check for any spelling
mistakes or typos.
2. Ensure that you are connected to the correct Uni-D port on
the NBN box.
3. Try an alternative network cable to connect your router to the
NBN box.
4. Ensure that the router is configured in WAN mode.
Technical Support
If you require assistance setting up your BYO device our team is available.
Live Chat: www.moretelecom.com.au
Phone: [phone]