Morphy Richards IB21008 Manual

MODEL21008
USING YOUR HAIR DRYER
After washing your hair, it’s really important to prepare it for styling. If you use lots of heated
styling tools on your hair, try and use a heat protection spray before you begin styling.
Always dry the excess water from your hair using a towel, then use a wide tooth comb to
detangle and smooth your hair.
To begin drying, remove the nozzle from your dryer and blast your hair with the dryer on the
highest speed setting until your hair is 50% dry – there is no point trying to style your hair
until it is almost dry. As your hair begins to dry, switch off your dryer and attach the
concentrator nozzle. Use the sectioning clips to split the hair into manageable sections –
this will ensure that each section is thoroughly dried and styled, as leaving moisture in the
hair can cause frizz. Using the nozzle helps to direct the airflow and will give your hair a
sleek and smooth finish. If you are blow-drying curly hair into a straight style, use the nozzle
to direct air down the shaft of the hair. If you want to create volume instead, tip your head
upside down and use your fingers to comb your hair through as you dry it.
As your hair dries, use the dryer on a slower speed setting so as not to blow your style out
of place. When you have achieved the style you want and your hair is thoroughly dry, press
and hold the ‘Cool Shot’ button for a blast of cold air to set your style in place. For hints
and tips on creating funky new styles, have a look at the style guide enclosed.
DON’T FORGET – to switch off your hair dryer and store it when you have finished drying!
If you want to store your hair dryer in the gift box, always make sure the hair dryer has
cooled down, and never wrap the cable around the product, as this can cause damage.
2 YEAR GUARANTEE
It is in your interest to retain the retailer’s receipt as proof of purchase. Please quote the
model number if the product develops a fault. This number can be found on the handle of
the product.
All Morphy Richards products are individually tested before leaving the factory. In the
unlikely event of any appliance proving to be faulty within 28 days of purchase, it should be
returned to the place of purchase to be replaced.
If a fault develops after 28 days and within 24 months of original purchase, you should
contact the Helpline number quoting the model number of the product, or write to the
address below. You will be asked to return the product (in secure packaging) to the
address below along with a copy of proof of purchase.
The After Sales Division, Morphy Richards Ltd, Talbot Road, Mexborough, South Yorkshire,
England, S64 8AJ
Helpline (8.30-5.00 Mon-Thurs/8.30-4.00 Fri)
UK 0870 060 2614 • Republic of Ireland 1800409119
For extra tips on styling, and details of the rest of the products in the Morphy Richards
range, please see our website www.morphyrichards.com
Morphy Richards products are intended for household use only. Morphy Richards has a
policy of continuous improvement in product quality and design. The company therefore
reserves the right to change the specification of it’s models at any time.
Registered address:
Morphy Richards Ltd, Talbot Rd, Mexborough, South Yorkshire, S64 8AJ
SAFETY INFORMATION
When using your hair dryer, you must follow basic safety precautions. Please read these
instructions carefully before using the product and keep them in a safe place for future
reference.
01 Use this appliance for it’s intended use only.
02 To protect against the risk of electric shock, do not immerse the appliance in water or in
any other liquids.
03 Check that the voltage on the rating plate of the hair dryer corresponds with your house
electricity supply which must be AC (alternating current).
04 Always unplug the appliance when it is not in use.
05 Do not leave the hair dryer switched on whilst unattended.
06 In the event of cable damage, do not attempt to replace the mains cable – return to
Morphy Richards.
07 It is recommended that the product should not be used by children.
08 For UK only - Do not take this product into a bathroom or use near a water basin or
any other vessels containing water. For other European countries - For additional
protection, the installation of a residual current device (RCD) having rated residual
operation current not exceeding 30mA is advised in the electrical circuit supplying
the bathroom. Ask your installer for advice.
09 Ensure the filter is cleaned regularly.
CLEANING THE FILTER
The air filter ensures that only clean air is used to dry your hair. To remove the air filter,
make sure your hair dryer is unplugged from the mains supply, and clip off the rear cover to
reveal the air filter. To do this, hold the body of the dryer firmly, and pull the cover to release
the filter. Take out the filter to clean away hair and lint using a vacuum cleaner. Ensure the
filter is completely dry before refitting. To refit, locate the air filter into the filter cover and
click back into place.
WIRING
This product is fitted with a 13 amp (BS1363) plug. A 13 amp fuse (BS1362) must be used.
Check that the voltage on the rating plate of your appliance corresponds with your house
electricity supply, which must be AC (alternating current). If the socket outlets in your home are not
suitable for the plug supplied with this appliance, the plug should be removed and the appropriate
one fitted.
WARNING: The plug removed from the mains lead, if severed, must be destroyed as a
plug with bared flexible cord is hazardous if engaged into a live socket outlet.
MAINS LEAD
As a safety precaution and to prolong the life of your appliance, do not wrap the mains lead
around the appliance as this can cause damage.
Part Number
PC21008M UK rev 1
1800WAC DRYER
Concentrator Nozzle
2 Speed Settings
3 Heat Settings
Cool Shot
Removable Filter
Hanging Loop