Moss LED Cinema User manual
OPL11V2735455565
FULL-SPECTRUM
WORK LIGHT
CINEMA MOSS LED INC.
2000 Lumens
Output
3Brightness
Levels
180° Adjustable
Handle
Li-IonRechargeable
Battery
Hi-CRI Minimum ≥95 CRI
and ≥95 TLCI
IP65 Rated for Outdoor Use
The only colour temperature
adjustable work light.
Designed for discerning
professionals who require
the best light quality available.
2700k
3500k
4500k
5500k
6500k
OPERATING INSTRUCTIONS
FOR THE MOST UP TO DATE MANUAL PLEASE CHECK WEBSITE
OR SCAN QR CODE USING CAMERA APP ON YOUR PHONE
YOU MAY NEED TO ENABLE ‘SCAN QR CODES’ IN YOUR SETTINGS
Light Source
Lumens
Operating Temperature
Degree of Protection
Charging Time
Charging Input
Operating Hours
High CRI Bi-Colour COB LED
2000 lm - Full Power
1000 lm - Normal Power
500 lm - Low Power
-10°C ~ +40°C
IP 65, IK 07
3.5 hours
DC 15V 1.5A
2 hours - Full Power
4 hours - Normal Power
8 hours - Low Power
Battery Specication Li-Ion 11.1V, 4400 mAh, 48.84Wh
CINEMA WORK LIGHT
OPERATING INTRUCTIONS
Thank you for choosing a product from Moss LED.
We hope that you will enjoy using your new Cinema Work Light.
Please read all instructions carefully and observe all safety rules.
Failure to do so can result in injury and damage to property.
Moss LED assumes no liability for misuse against our operating
instructions.
224 (8.81”)
199 (7.83”)
74 (2.91”)
• Do not open the device
• Do not look directly into the light output COB
• Do not operate in direct sun light or in extreme temperatures
• Keep away from children
• Do not illuminate the device with the lens closer than 2” to a surface
– it can overheat and cause objects to catch re!
• Operating the lamp while pressed to a surface can lead to re
• Do not subject the charger to wet environments. The charger is
only to be used indoors.
• Always only use the Moss LED supplied charger for charging the lamp
• Fully charge the battery before storing the lamp
Press the main power switch to turn the light on and off
Press the CCT switch to adjust between colour temperature modes
Press the lumen switch to adjust between high, medium
and low power modes
The cinema work light has a built-in memory which remembers
its previous CCT and lumen output settings
Switch lamp off during charging, and connect the charger to the light.
This will charge the battery. The lamp can be operated while plugged
into the charger however the battery will not charge. The battery
indicator will blink during charging. If the battery indicator does not
illuminate please disconnect and try again.
• Do not use the device if there is damage to the housing, the plug,
plug cover, charger, or cable assembly.
• Do not open the light or charger.
All repair work must be carried out by a Moss LED certied technician.
• Perform cleaning tasks to the light and charger only
when the mains plug disconnected.
• Do not place the light face down on a surface while illuminated.
• Protect the battery against heat. Ex. Direct sunlight, re etc.
• If the battery is damaged uids can leak from the battery.
avoid contact with leaking battery uid. These uids can lead to skin
irritation or burns. Rinse thoroughly any liquid that comes in contact
with your skin.
Seek urgent medical help if the uid makes contact with your eyes.
• The light & charger shall not be discarded in normal
household waste under any circumstances
• Dispose of the device via an authorized disposal center that
is capable of properly recycling batteries & electronic waste
• The light and charger have valuable materials in them
that can be recycled.
• Please recycle!
• Contact your waste disposal facility if you have any questions regarding
safe disposal. All packaging materials can be recycled.
• The light & charger have a 1 year warranty against faulty workmanship
or materials. This guarantee does not apply to damage to the devices
arising through a failure to comply with the operating instructions.
• This manual is subject to change and we assume no liability for errors.
Table of contents
