Motoalliance Denali MA11722 User manual

866.527.7637 1 [e-mail]
23001 Industrial Blvd, Rogers, MN 55374 / 1-866-527-7637
www.motoalliance.com
Denali PLOW MOUNT
MA11722
Yamaha YXZ
Thank you for purchasing our Denali plow mount(s). You now own a premium,
custom plow mount to allow you to use your plow with your SxS. Please note the
following instructions and heed all warnings.
•Your UTV/SxS and/or plow system can cause death or injury, please use
caution and common sense when operating your unit.
•Read your Plow Operator’s Manual, your Winch Operator’s Manual, and all
warning labels before operating your UTV/SxS.
•Operate your SxS at a walking speed with the blade installed. Do not
exceed 5 mph (8 km/h) even with the blade up.
•Do not operate the UTV/SxS on slopes greater than 10 degrees with the
plow installed.
•Always lower the plow to the down position before leaving your UTV/SxS
unattended.
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

MotoAlliance
MA11722 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 2 [e-mail]
Please verify that all hardware and parts are included in your package.
Kit Content: Please refer to Figure 1
Item
Qty
Description
1
1
MA11722-W1 Plow Mount
2
1
MA11722-W2 Front Mount Strap
3
1
MA11722-W3 Back Mount Strap
4
2
5/16”-18 x 1.25’’ Serrated Flange Bolt
5
2
½” Flat Washer
6
2
½” Lock Washer
7
2
½”-13 x 1.50 Hex Head Bolt
Figure 1

MotoAlliance
MA11722 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 3 [e-mail]
MA11722 Plow Mount Installation
1. Remove the front section of the bottom skid plate.
NOTE: This will remain off the vehicle while the plow mount is installed.
Figure 2
2. Lift the plow mount into place as shown in Figure 3 and Figure 5.
Figure 3

MotoAlliance
MA11722 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 4 [e-mail]
3. Set the front strap into place behind the cross support.
4. Install the 5/16” hardware but do not tighten at this time.
5. Set the back strap into place in top of the cross support as seen in Figure 4.
Figure 4
6. Install ½” hardware as seen in Figure 4 and Figure 5 but do not tighten at this
time.

MotoAlliance
MA11722 23001 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 5 [e-mail]
7. Verify that the mount is squared up with the machine and tighten down all
hardware.
Figure 5
8. Use the pins supplied with your Denali Plow System to attach the plow to the
mount.
9. Retighten all hardware after the first use, continue to retighten hardware
seasonally.