01
02
03
EN
PROGRAMMING
PROGRAMMINGRECEIVER INSTALLATION
It is very important to choose the place of installation
carefully in order for the transmitter and the receiver to
function well. Capacity is not only conditioned by the
technical features of the device, but also varies depending
on the radio-electric conditions of the place.
The receiver is provided with a local antenna. If you choose
an external antenna, it should be positioned on the outside,
in highly visible spots and away from metal structures.
You can not install two receivers if not respected a minimum
distance of 5 meters between them.
Installation:
01 • Fix the support on the wall.
02 • Place the board on the suport, sliding it between the
existing support ledges.
03 • Place the cover to close.
Programming of the radio controls must be carried out with the antenna disconnected, up to a
maximum number of 500 codes.
• COMMAND PROGRAMMING
01 • Press the
programming button
once.
02 • The LED will start
flashing. 03 • Send the code with
the radio control to be
programmed.
When you press the key of a command recorded in the receiver, the output will be activated for 1
second in the monostable mode, and it will change state in the bistable mode.
• ACTIVATE THE OUTPUT
To delete all commands in memory, press the button for 10 seconds. The output will be activated
for one second and the led will flash 5 times.
• RESET THE RECEIVER
Led stays on: programming is complete.
Led blinks rapidly (32 times): Memory is full.
