Motorola solutions V300 Service manual

V300TM
FULL V300 USER GUIDE:
www.motorolasolutions.com/v300-userguide
QUICK START REFERENCE
QUICK START GUIDE | V300
1. GPS
2. Streaming
3. Storage
4. Recording in Progress Duration
5. Battery Level
6. WiFi Connection & Signal Strength
POWER:
Press and release the power button to power the V300 on or off.
RECORD START/STOP:
Press the record start/stop button to startor stop a recorded
event.
PRESS THE DISPLAY BACKLIGHT BUTTON TO:
• Turn on the backlight for the LCD display.
• See the camera status or review categories for a
recording.
• Start momentary mute.
FUNCTION BUTTON:
Press and hold to enter/exitcovert mode orto tag an event.
Function Button
Display Backlight
Button
Status LED
Electronically-
Adjustable Field of View
Dual Microphones
Recording LED
Record Start/
Stop Button
Power Button
1 2 3 45 6

TRANSFER STATION II
Stand-alone
battery
Powerand Link
LEDs
Slot LEDsSlot IDV300 Camera
FULL TRANSFER STATION II QUICK START GUIDE:
www.motorolasolutions.com/ets
Motorola Solutions Inc., 500 W Monroe St, Chicago, IL 60661. U.S.A. motorolasolutions.com MOTOROLA, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks
of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. ©2023 Motorola Solutions, Inc. All rights reserved.
WGD00171
SETUP
1. Connect the ethernet cable to the ethernet connector on
the back of the Transfer Station II.
2. Connect the power cable to the power connector on the
bottom of the Transfer Station II and plug the power cable
into an electrical outlet.
3. Power the Transfer Station II ON using the switch on the
back. The serial number is located on the bottom.
4. Connect the other end of the ethernet cable to a
computer that you have set up to access the Transfer
Station II factory default configuration web page.