m
IMPRES REMOTE SPEAKER
MICROPHONE (RSM)
3.5 MM AUDIO JACK, NOISE
CANCELING, EMERGENCY,
IP54 PMMN4081
Accessories
*68012008030*
68012008030-C
FOREWORD
RF Energy Exposure and Product Safety
Guide for Portable Two-Way Radios
ATTENTION!
Before using this product, read the RF Energy Exposure
and Product Safety Guide that ships with the radio which
contains instructions for safe usage and RF energy
awareness and control for compliance with applicable
standards and regulation.
Acoustic Safety
Exposure to loud noises from any source for extended
periods of time may temporarily or permanently affect
your hearing. The louder the radio’s volume, the less
time is required before your hearing could be affected.
Hearing damage from loud noise is sometimes
undetectable at first and can have a cumulative effect.
To protect your hearing:
• Use the lowest volume necessary to do your job.
• Turn up the volume only if you are in noisy
surroundings.
• Turn down the volume before connecting headset
or earpiece.
• Limit the amount of time you use headsets or
earpieces at high volume.
• When using the radio without a headset or
earpiece, do not place the radio’s speaker directly
against your ear.
Recommended RSM Wearing Position
Attaching the RSM to the Radio RSM Features Transmitting
1. Connecting the RSM to the radio will disable the
radio’s speaker, but will not disable the radio’s
microphone and PTT.
2. Turn the radio off before connecting the RSM to
the radio.
Push-to-talk
(PTT) Button
* Check with your dealer for available
programmable functions.
Accessory Orange Button*
Receive-only 3.5 mm
Earphone Jack
(Unthreaded) covered
by Dust Cap
For optimal noise cancelling performance, speak
directly facing the microphone.
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and
the Stylized M logo are trademarks or registered
trademarks of Motorola Trademark Holdings, LLC and
are used under license. All other trademarks are the
property of their respective owners.
© 2012, 2013 Motorola Solutions, Inc.
All rights reserved
68012008030_c.fm Page 1 Tuesday, May 14, 2013 1:04 PM
