Mould King 16039 User manual

Mould King16039 Quick Pitch Supplies

MouldKing 16039Lighting KitsInstallationInstruction
Note:
1. The cable should be placed between or under bricks.
2. The cables should be set around the studs.(Shown as below)
3. Please pay attention to the direction of the wire socket: the side of the socket with exposed
wires should face the welded "=" symbol(As Shown below). If the plug is hard to insert, do not
insert it forcefully, otherwise the pins of the socket will be bent or the socket will be overheated
and damaged
Please read this instruction before building, the lighting kits should be installed during building

Lighting kits installed inStep 207
Take out a warm light strip Start to paste the warm strip
as shown in the red box below
Warmlight strip pasted as shown Cable arraged as shown

Cover the bricks
Cover the bricks Take out another warm light strip
as shown in the red box below
Start to paste the warm strip Warm light strip pasted as shown
Light kits installed in Step 288

Cable arraged as shown
Cable arraged as shown Cover the bricks
Lighting kits installed in Step 435
warm light socket
Take out a 350mm dual interface cable and a Fix the socket on the bottom plate
as shown

Pull out the cables
Pull out the cables Take out a battery box and a
six-port socket, link them
Link the cables withthe sockets
tape
Wrap the organized wires with

battery box here
Put the arranged cables and
Put the arranged cables and
battery box here
Installation complete
Have a Great Time!