Moultrie MCG-13039 User manual

Instructions for HD Video Glasses
THANK YOU for your purchase of the HD Video Glasses. Please read this booklet before using the
unit. If you should have any questions about this product or any other Moultrie product, please
contact us using the information on the back of this booklet. Please register your glasses at
www.moultriefeeders.com/warranty to activate your warranty.
www.moultriefeeders.com
06232015 / MCG-13039
PRADCO Outdoor Brands • 3280 Highway 31, Ste B • Calera, AL 35040
FCC Statements
Moultrie Products
MCG-13039
Note: changes and modifications not expressly approved by the party responsible could void the user’s authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: This device complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable
protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy
and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference
will not occur in a particular installation. If this device does cause harmful interference to radio or television reception,
which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- lncrease the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
HD Video Glasses
Micro SD Card Slot
(card is pre-installed)
On/Off Button
Glasses Lens
Charging/Recording
LED Indicator
USB Port
Reset
Recording
LED Indicator
HD Video Glasses_Manual-ENGLISH_6-23-15.indd 1 6/23/15 2:14 PM

HD Video Glasses HD Video Glasses
Page 11
Moultrie Limited Warranty
This product has been thoroughly tested and inspected before shipment. It is guaranteed from
defects in material and workmanship from the date of purchase for 1 year. Under this limited
guarantee we agree to replace or repair free of charge any part or parts which have been found to
be defective in original material or workmanship. Should you require in-warranty service, call our
Customer Service Department. If your problem cannot be addressed over the telephone, we may
need you to send us your defective product plus proof of purchase.
You must register your glasses at www.moultriefeeders.com/warranty to activate
your 1-year warranty.
Troubleshooting
Please visit www.moultriefeeders.com/contact-us for troubleshooting and helpful tips.
Returns and Repairs
Please visit http://www.moultriefeeders.com/return-policy and complete the form or our
Service Department will gladly answer any questions you have. Call 800-653-3334,
Monday - Friday, 8:00 AM to 5:00 PM CST.
IMPORTANT INFORMATION
G
WHAT’S INCLUDED
A
HD Video Glasses
Clear & Polarized Lenses
8GB Micro SD Card
USB Cable
Carry Case
Cleaning Cloth
User Manual
CHARGING
B
Please charge the product rst if it could not be powered on at rst use. The charging steps
are as follows:
A. Please connect the glasses to a standard AC USB charger (output 5V 1A) via the included
mini 5 pin USB cable and plug the charger into the 110v/220v power socket for charging.
The Red LED indicator stays on while charging the glasses, the Red LED indicator will turn o
and Green LED will stay on once the glasses is fully charged.
B. It is advised that you use our original charger or connect the glasses to PC via USB cable
for recharging. For safety consideration, please don’t use charger with other specications.
Page 2
HD Video Glasses_Manual-ENGLISH_6-23-15.indd 2 6/23/15 2:14 PM

HD Video Glasses HD Video Glasses
OPERATING INSTRUCTIONS
C
With only one Power ON/OFF button and one Reset button, the operation of this device is
easy and convenient. Operating instructions are as follows:
1. Power ON & START Recording:
Press the Power ON/OFF button for 2 seconds and both the green and blue LEDs will light up.
The blue LED will then start to ash, indicating that the glasses are recording.
2. Power OFF & STOP Recording:
Press the Power ON/OFF button for 2 seconds to stop recording. The glasses will save the
recorded les and then turn o. If you don’t stop it manually, the glasses will keep on
recording and saving one video le every 20 minutes. The glasses will stop recording
automatically when in runs low on power or the micro SD card is lled.
(Note: If the glasses lose power or the micro SD card is lled, they will turn o automatically
and the last video le may be less than 20 minutes.)
Page 3Page 10
SPECIFICATIONS (cont.)
F
PC/Laptop System requirements:
CPU must be at least Pentium 2.0Ghz Dual-core or above
Operation system: Mac OSX10.7/Windows XP or above
4GB free hard disk memory or above
2GB RAM or above
Graphic displayer minimum 512M memory, support 1080P resolution or above
HD Video Glasses_Manual-ENGLISH_6-23-15.indd 3 6/23/15 2:14 PM

HD Video Glasses HD Video Glasses
OPERATING INSTRUCTIONS (cont.)
C
NOTE:
A. Please make sure that the glasses are powered OFF before removing the micro SD card
to avoid damage to the glasses.
B. Make sure that the micro SD card has enough space before use. If not, delete some les
or format the card with your computer to make sure there is enough space for recording.
C. If your glasses fail to respond, press the“RESET” button and restart the glasses.
D. If after pressing“RESET” the glasses fail to respond, let them fully recharge before
using again.
Page 4 Page 9
SPECIFICATIONS
F
Resolution 1280 x 720P @ 30fps
Image sensor CMOS sensor
Product size 6.8” x 6.8” x 1.7” (unfolded)
Power supply Embedded 550mAh Li-ion Battery
Power duration About 160 minutes
Power Adaptor 5V DC / 1A
Power Consumption <0.6W
Memory Support Max high speed 32 GB Micro SD card
(CLASS 10 or above is required)
Video Format M-JPEG
Working temp 23º – 104º F
Storage temp -4º – 140º F
Physical weight 2 oz.
USB 2.0 (HS)
Player KM Player; Quick Time; RealPlayer, Window Media Player
Operating System Win8, Win7, Windows XP, Mac OS 10.7 or above
HD Video Glasses_Manual-ENGLISH_6-23-15.indd 4 6/23/15 2:14 PM

HD Video Glasses HD Video Glasses
Page 5
3. Data Transmission:
Ensure your glasses are powered OFF. Connect the glassed to your PC via the USB 2.0 port.
Now you can start data transmission from the glasses to your PC.
4A. Set Date & Time (web, recommended):
A. Connect the device to a PC, and type in the URL
www.moultriefeeders.com/hd-video-glasses
into your web browser. Use the “Set My Date & Time”button to automatically create the
“setdate.txt”le. When prompted, save the le to your desktop. Simply drag this le onto your
SD card to transfer the le and set your date and time.
4B. Set Date & Time (manual):
A. Connect the device to a PC, and create a“ .txt” le named “setdate”;
B. Open the new“setdate.txt” le and type a number like “20151108090828”, save the
“setdate.txt “ le and exit to complete time setting;
The date format is:
2015 11 08 09 08 28
Year Month Date Hour Minutes Seconds
Note: the camera time uses the 24-hour system.
C. Disconnect the glasses from PC and remove the USB cable. Press “Power ON/OFF”button
to start the glasses to update the time setting.
OPERATING INSTRUCTIONS (cont.)
C
Page 8
Status Green LED Blue LED Red LED
Power on Stay on Stay on 3 secs then ash O
Power o Stay on 1 sec then o Stay on 1 sec then o O
Recording Stay on Flash once per sec O
Without SD card Stay on 30 secs then o Stay on 3 secs then o O
Card is full Stay on 5 secs then o Stay on 5 secs then o
Low battery Flash 20 secs then o Flash 10 secs then o O
Charging Stay on O Stay on
Fully charged Stay on O O
LED INDICATOR STATUS
E
HD Video Glasses_Manual-ENGLISH_6-23-15.indd 5 6/23/15 2:14 PM

HD Video Glasses HD Video Glasses
Page 6
SWAPPING LENSES
D
A. Loosen the lens on the sides to remove it. To do so, slightly press the lens into the direction
of the arrow to release it from the groove. Next slightly lift the lens to the front.
B. Slightly press the lens into the direction of the arrow to release it from the groove.
Next, slightly lift the lens to the front.
C. Remove the lens from the groove. Then you can remove the lens completely.
SWAPPING LENSES (cont.)
D
A. To mount the lens, start by inserting it into the lower groove.
B. Fix the lens into the upper groove by pressing it against the glasses case.
C. Laterally x the lens by pressing it into the direction of the arrow against the glasses case.
Double-check that the lens seats properly in the groove and, if necessary, re-adjust and x it.
Page 7
AA
B
C C CC
B
A A
HD Video Glasses_Manual-ENGLISH_6-23-15.indd 6 6/23/15 2:14 PM