Moultrie MCG-13200 User manual

Instructions for Game Spy 2 Plus
Digital Game Camera
THANK YOU for your purchase of a Game Spy 2 Plus Digital Game Camera. Please read this booklet before using the
unit. If you should have any questions about this product or any other Moultrie product, please contact us using the
information on the back of this booklet. Please register your camera at www.moultriefeeders.com/warranty to
activate your warranty.
Infrared LED Flash
Up/Down Buttons
SD Card Slot
Camera Lens
LCD Display
Mode Selector Switch
Motion Sensor
Battery
Compartment
Status Indicator
Micro USB Port
Light Sensor
OK Button
1/4” 20 Mount
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 1 2/3/17 11:09 AM

2
QUICK START INSTRUCTIONS
A
Battery Installation
Open the camera cover and install 6 AA Alkaline or Lithium batteries. Make sure that the (+ and -) polarities match the polarities indicated
inside the battery chamber.
Note: Anytime you load or unload batteries, make sure that the camera is OFF.
Insert SD Card
You will need to open the front cover to insert an SD memory card. You can insert a
SD Card up to 32 GB (not included). Insert the SD card in the direction indicated on the
card, until you hear an audible click.
Note: Camera will not operate without an SD memory card installed.
Ultra/turbo SD cards are not recommended.
Power ON
Slide the Mode Switch to the Setup position. The time will appear on the
LCD Display. The camera has powered up.
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 2 2/3/17 11:09 AM

3
Mounting with a Strap
Close cover and place camera on a tree or pole approximately 3 ft. high.
Thread the mounting strap through the mounting strap slots on the back
of the camera and secure.
Hint: If you are mounting camera to cover a trail, face the camera down
the trail tilted at a slight downward angle.
Face the camera north or south to avoid over exposure from the sun.
Clear brush away from camera front to avoid false triggers from the wind.
Camera Setup
Battery Installation
Open the camera cover and install 4 C-Cell
Alkaline batteries. Make sure that the
(+ and _) polarities match the polarities
indicated inside the battery chamber.
Note: Anytime you load or unload batteries,
make sure that the camera is OFF. If using
12V DC Power Panel Plug, do not remove
internal batteries.
Insert SD Card
You will need to open the front cover to
insert a SD memory card. You can insert a
SD Card up to 32 GB. Insert the SD card in
the direction indicated on the card, until you
hear an audible click.
Note:Camera will not operate without
an SD memory card installed.
Power ON
Slide the (Mode) Switch to the (Setup)
position. Press and hold the (ON/OFF)
Button until the time appears on the LCD
Display. The camera will power up.
Mounting with a Strap
Close cover and place camera on a tree or
pole approximately 3 ft. high. Thread
the mounting strap through the mounting
strap slots on the back of the camera
and secure.
Hint: If you are mounting camera to cover a
trail face the camera down the trail tilted at
a slight downward angle.
Face the camera North or South to avoid
over exposure from the sun.
Clear brush away from camera front to
avoid false triggers from the wind.
NO
Trail
YES
Trail
7
Eyelet
Mounting
Strap
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 3 2/3/17 11:09 AM

CAMERA SETUP
B
4
Power ON
Slide the power switch to the ON position. The battery level will appear on the LCD Display
for 2 seconds.
99
Hi
Hi
If the camera detects that the battery level is 15% or below, the Low Battery screen will
appear and the unit will turn o.
After 2 seconds, the camera will display the countdown. When the countdown timer reaches
“00”, the display will turn o and the camera will OK Capture Mode.
09
Hi
To begin modifying the camera settings, slide the switch to the SETUP position. The camera will display the currently set time. Use the UP and DOWN
arrow keys to change the currently ashing option. Once setting is adjusted to the desired option, press OK to lock in the setting and move to the
next eld/option.
Note: while in SETUP mode, the motion sensor will detect movement and illuminate the STATUS LED on the front of the camera for ~1 second.
You can use this feature to ensure camera is properly aimed to detect movement in the desired target area.
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 4 2/3/17 11:09 AM

Setting Time and Date
While the camera is in the Setup mode, the LCD display will show the time.
Press the OK button and the selection will ash. Use the UP/Down buttons to
change the selection. Press the OK button to lock in the selection and move to
the next selection. Repeat the process to set the year, month and day.
Detection Delay Setting
Detection Delay determines the number of minutes between pictures when
an animal is detected and remains in range. Press the OK button. Use the
Up/Down buttons to choose between (5, 15, 30 sec, 1 or 5 min). Press OK to
lock in your selection and move to the next selection.
AM
Hi
AM
Hi
Setting Capture Mode
Use the Up/Down buttons to choose between 6 dierent modes:
1 Photo/Low Resolution, 1 Photo/High Resolution, 3 Photos/Low Resolution,
3 Photos/High Resolution and High/Low Video. Press OK to lock in your selection
and move to the next selection.
The on-screen icons for each mode are shown to the right:
1
Hi
Hi
1
Lo
Lo
3
3
Hi
Lo
1 Photo, Low Resolution
1 Photo, High Resolution
3 Photos, Low Resolution
3 Photos, High Resolution
High Resolution Video
Low Resolution Video
5
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 5 2/3/17 11:09 AM

6
CAMERA SETUP (cont.)
B
Setting Camera ID
Use the Up/Down buttons to choose between nine dierent numbers (1-9) to help identify
your cameras (i.e. “CAMERA 3” will be marked on the info strip given 3 was selected).
Press OK to lock in your selection and move to the next selection. Hi
Reset Picture Count/Erase Images/Format Card
You can reset the picture count on the camera. Use the Up/Down buttons to choose
between Yes or No. Press the OK button to conrm the selection. “Yes” will reset
le number to start from 0001 and erase all images stored on the SD card.
NOTE: This will also format your SD card for use in your camera.
Hi
SET
TIME
SET
DATE
SET
OPTIONS
HOUR
MONTH
MINUTE
DAY
AM/PM
YEAR
DELETE/
FORMAT SD
OK
DETECTION
DELAY
CAPTURE
MODE
CAMERA
ID
OK
OK OK
OK OK OK
OK
OK
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 6 2/3/17 11:09 AM

Important Battery lnformation
- Only use Alkaline or Lithium batteries. We recommend the use of Energizer batteries.
- Do not mix old and new batteries. Always replace ALL the batteries at the same time.
- When the camera is not in use, please remove the batteries.
Moultrie Limited Warranty
This product has been thoroughly tested and inspected before shipment. It is guaranteed from defects in material and workmanship from
the date of purchase for 1 year. Under this limited guarantee we agree to replace or repair free of charge any part or parts which have been
found to be defective in original material or workmanship. Should you require in-warranty service, call our Customer Service Department.
If your problem cannot be addressed over the telephone, we may need you to send us your defective product plus proof of purchase.
You must register your camera at www.moultriefeeders.com/warranty to activate your 1-year warranty.
Troubleshooting
Please visit www.moultriefeeders.com/contact-us for troubleshooting and helpful tips.
Returns and Repairs
Please visit http://www.moultriefeeders.com/return-policy and complete the form or our Service Department will gladly answer any
questions you have. Call 800-653-3334, Monday - Friday, 8:00 AM to 5:00 PM CST.
7
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 7 2/3/17 11:09 AM

FCC Statements
Moultrie Products
MCG-13200
Note: changes and modifications not expressly approved by the party responsible could void the user’s authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.
SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: This device complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This device generates,
uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- lncrease the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
02032017 / MCG-13200
Game Spy 2 Plus
www.moultriefeeders.com
PRADCO Outdoor Brands • 3280 Highway 31, Ste B • Calera, AL 35040
MCG-13200_Game Spy 2 Plus (2017) manual_ENGLISH_2-3-17.indd 8 2/3/17 11:09 AM