Mount-It! MI-7977 User manual
PROJECTOR-STAND
Assembly Instruction
MI-7977
Weight capacity: 8KG
Top tray tilt angle: 0°~30°
Adjustable height: 890mm~1400mm
Key Feature:
It can be used to support projectors, laptops and other
equipment.
Holding top tray can support equipment up to 14in X11in.
Height and angle can be adjusted to use your equipment
while sitting or standing.
For easy of portability, the holding top tray can be
seperated from the tripod legs.
1
Part list:
Tripod base X1 Top tray X1Pole X1
Hardware list:
A-Knob
1PCS
B-Screw
1PCS
C-Washer
2PCS
D- Nut
1PCS
CAUTION!
WARNING
！This Product should be assembled with care.
If the tray is not properly installed it may fall,
resulting in possible injury and/or damage.
2
Step1
Step2
Unfold tripod base, adjust to desired height
and tighten lower knob.
Adjust desired height,
then tighten the knob.
Tighten the knob.
Place screws into tripod base.Inset the
pole and adjust to the desired height then
tighten middle knob.
According to your preferences,
the knob can be in the
left or the right.
Using the upper knob to fixed top tray.
The knob can be in the left or the right.
mm
mm
mm
mm
3
Step3
Step4
Install top tray using the screw provided.
1400
