Presentation Switchers PS111 User manual

Page 1PS111 Quick Start Guide
Getting to Know the PS111
The graphic below points out key a ributes of the PS111.
Front View
Back View
Connections
Inputs and Outputs. Using the graphic above, connect the source devices to the ports labeled
above as, “Connect Source Devices Here”, and the display at loca on, “Display Output”, port.
Connect audio, if applicable.
Power. Connect the DC power supply to the loca on, “DC/5V”, and the other end to your 110V/
VAC power socket. The system LED will illuminate below and to the le of the DC/5V loca on.
Quick Start
Connect Sources Devices Here
IR (Infra-Red) Sensor
Source Selector
Active Source Indicator
Stereo Audio Output
Display Output USB Firmware Update
EDID Resolution Select
Power Indicator

Page 2 Presentation Switchers, Inc.
Auto-Sense, Auto-Switching
In many situa ons a control system is o en unnecessary, complicated, costly, and confusing.
When a new device is connected to the PS111 system, it is immediately switched to the display.
This feature is especially useful in board room and collabora ve presenta on systems.
Selecting a New Source Device to Display
To display a new source, press the Source Selector bu on on the Front of the PS111 repeatedly
un l the LED on the Ac ve Source Indicator corresponds to the desired Source Port Selec on.
The image should now be visible on the Display Output and can be heard on the Stereo Audio
Output connectors.
Note: Selec ng an input for a source that is not physcially connected will cause the output
display to indicate that the signal has been lost or disconnected.
Selecting a New Source Device to Display
(Using IR Remote)
From the IR Remote controller, shown below, select the Right or Le bu ons un l the desired
Source is selected. If the front panel is viewable, you will see the Ac ve Source Indicator change
when each bu on is pressed.