Mountain Buggy Urban Jungle Designer User manual

mountain
buggy®
life without limit
WARNINGS
Check you have the correct travel system for your carseat.
WARNINGS
Do not use this travel system until you have read and understood
the instructions!
WARNINGS
Never leave your child unattended.
WARNINGS
Do not use accessories not designed for your buggy as they may be unsafe.
WARNINGS
Do not leave your baby in carseat (on or off stroller) for long periods of time.
installation instructions
urban jungle™
universal travel system
mountain
buggy®
life without limit
For any assistance, please contact your nearest retailer listed at
www.mountainbuggy.com
Model MB1-CLIP1
Issue August 2009
Safety certified: ASTM F833-08
EN 1888:2005
AS/NZS 2088:2000
send 102-112 Daniell St, Newtown 6021, Wellington, New Zealand
ph [phone]
fax [phone]
Designed in New Zealand. Made in China.

FITTING TRAVEL SYSTEM TO BUGGY (continued)
3. Ensure fabric passes over and around frame tubes.
4. Open snap locks and press travel system onto frame directly above
bottom fasteners on side tubes.
5. Close both snap locks down flat, making sure you hear the lock
“click indicating they are fully locked.
OPEN POSITION
30mm
Snap
Lock “CLICK”
CLOSED POSITION
Bottom
Fastener
Z
IMPORTANT CHECKS
• Makesurebabyisharnessedintocarseatusingthemanufacturer’s
instructions.
• Whenttingcarseatontotravelsystem,ALWAYSkeepasteadyhand
on carseat and baby.
• Checktravelsystemisengagedcorrectlyontobuggyframeand
cannot move in any direction. (Refer back to installation instructions
to ensure positioning of snap locks are correct).
• Donotusetravelsystemifyouareunabletosecurecarseatortravel
system. In this case, contact your store/distributor where the buggy
was purchased from, for more help.
• Itisrecommendedthatyoupractisethefollowinginstructionswithout
baby in carseat.
PREPARING THE BUGGY
WARNINGS
ALWAYSputthebuggybrakeon.
Note: the sunhood and seat need to be removed from buggy before
fitting travel system.
1. Temporarily remove sunhood.
2. Unfasten seat from frame along side tubes,
including straps at point A & B on both sides
of buggy, and strap underneath seat at point C.
3. Remove seat.
FITTING TRAVEL SYSTEM TO BUGGY
1. Attach the fasteners on travel system
fabric to fasteners on buggy frame at
points A,B,C & D.
2. Fasteners at A&B are above sunhood lug.
Fasteners C & D are below hinge joint.
FITTING CARSEAT ONTO
TRAVEL SYSTEM
1. Place carseat in travel system so that
baby faces buggy handle bar.
2. Pass wide straps around frame directly
below sunhood lugs and through slots
provided on each side of carseat.
(the slots are the same as used for
carseat belt).
3. Buckle wide strap across top of carseat
at point Z and tighten firmly by pulling
on free end of strap.
Sunhood Lug
Wide Strap
A
D
B
C
Sunhood
Lug
Hinge Joint
REMOVE CARSEAT FROM TRAVEL SYSTEM
1. Unbuckle travel system buckle and remove straps from slots on carseat.
2. Lift carseat off travel system.
REMOVE TRAVEL SYSTEM FROM BUGGY
1. Open two snap locks and take snap locks off frame tube.
2. Unfasten four fasteners on frame and lift travel system off buggy.
C
A
B