MPP Solar PIP-HS User manual

Version: 1.2
User Manual
REMOTE PANEL MANUAL FOR
PIP-HS/MS/MSX INVERTER-CHARGER SERIES

Product Overview
Unpacking and Inspection
Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. You should
have received the following items inside of package:
Remote panel x 1
User manual x 1
RJ45 communication cable x 1
RJ11 cable x 1
RJ45 communication board x 1
RS232/RJ45 cable x 1
Installation
Step 1: Drill two holes in the marked locations with two screws. Place the box on the surface and align the
mounting holes with the two screws. Then, check if the remote panel is firmly secured.
Note: Installation to the wall should be implemented
with the proper screws. Refer chart for recommended
spec of screws.
Step 2: Please check communication port in inverter first. If it is equipped with USB communication port,
please replace USB communication board with bundled RJ 45 communication board by following below steps.
If it’s already with RJ45 communication port, please skip this step.
M3
Ø 5-Ø 9
60.00 mm
Communication port and power input: Power input of remote
panel.
Signal input: Signal input to remote panel.
Communication port: Connection to PC.
Power switch: Main switch of remote panel.
External power input: It’s necessary to have external +5VDC
power source when using inverter without dry contact.
On/Off switch for external power input.
Interface: Remote panel display, operation buttons and
indicators.

USB communication board RJ45 communication board
Step 1: Remove terminal cover.
Step 2: Remove USB
communication board.
Step 3: Put bundled RJ45
communication board in same place.
Step 3: Before wiring connection, please modify jumper setting of JP1 and JP2 in communication board as
below.
1KVA-3KVA inverter
1 3
JP1 1 3 JP1
1 3
JP2
1 3
JP2
Default communication board setting in inverter Modify setting in communication board
when using remote panel
4KVA-5KVA inverter
Default communication board setting in inverter Modify setting in communication board
when using remote panel
Step 4: If the inverter is not bundled with dry contact, please follow below diagram 1 for wiring connection. If

the inverter is bundled with dry contact, please follow below diagram 2 for wiring connection.
Use a RJ45 to RS232 cable bundled with inverter to connect communication port to PC. If the inverter is not
bundled with dry contact, it’s necessary to use an external +5V USB adapter to provide power for remote
panel.
Step 5: Connect remote panel to inverter with a 6-m RJ45 communication cable and a 6-m RJ11 cable (only
available for the inverter with dry contact, connect NC and NO port of dry contact) as below diagrams.
Diagram 1: Wiring diagram for inverter without dry contact
Diagram 2: Wiring diagram for inverter with dry contact
Operation
After main switch() and external power input switch(,only available for inverter without dry contact) are
powered on, users can monitor and control the inverter from a distance with the remote panel. Besides, users
also can monitor and control the inverter with PC software via communication port.
The AC output of the inverter can be powered on/off by remote panel. For the interface operation, please refer
to the inverter manual.