MODEM INSTALL INSTRUCTIONS
•
Remove the old modem
• Unplug the power supply from the wall.
• Disconnect the GREY cable from the wall that
plugs into the DSL port on the modem.
• Disconnect any Ethernet cables that are
plugged into the modem if applicable.
• Set the old modem, power cable and GREY DSL cable aside.
•
Connect the new modem
• Plug the new GREY DSL cable into the same
jack on the wall as the previous modem.
• Plug the GREY cable into the DSL port on the modem.
• Reconnect any Ethernet cables that
were previously plugged in.
•
Connect the power supply
• Plug new power supply into the modem, then
plug the other end into an electrical outlet.
• Aer you plug in the modem, wait for it to connect to the
network (indicated by a GREEN light next to the icon).
1
2
3
totalWiFiTM Wiring Diagram Router Wiring Diagram
•
Reconnect Ethernet Cables
• Reconnect any Ethernet cables that were previously
plugged in.
• Routers should be only plugged into the port labeled WAN
(see step 6).
• If you have totalWiFiTM leave the WAN port empty (see step 5).
•
Using totalWiFiTM
• Reconnect by using the Wifi Network Name (SSID) and
Wifi password that is printed on the device lable.
• Test your connection.
•
•
Using your own Router
• Plug your router into the port labeled WAN
on the modem using an Ethernet cable.
• Wait for the connectivity light on your router to turn on.
• Test your connection.
5
4
6
Questions? Contact our support team at (907) 745-6821
