IMPORTANT SAFEGUARDS
• The product contains sharp blades!
Handle with care when assembling the
product or cleaning the blades.
Do not use to cut any food with a hard shell,
such as coffee beans, shells, bones, etc.
• Do not leave the product within reach of
children.
• Do not put this product in an oven or
microwave oven.
• Use the container for food processing
only. It is not intended for food storage.
• Do not use the product if it is damaged in
any way.
• Never place the product on a hot surface
or close to an open flame.
• Use this product to cut food such as
vegetables, herbs, fruit, meat, nuts, etc.
• Use, wash and store with care.
• This product is designed for household
use only. Do not use other than for its
intended purpose.
Note: To reattach the two covers,
match the Bottom Cover slot with the
Top Cover slot and snap the covers
back in place.
Speed-control Switch
Pulling Handle
Chopping Blades
Blade Protector
Container
PARTS
INSTRUCTIONS
• Remove the Blade Protector from the
Chopping Blades.
• Clean the parts before using the
product for the first time.
BEFORE FIRST USE:
2. Place the Chopper Blades on the
pin located inside the Container.
1. Place the Container on a flat,
stable surface.
2/3
Note: Be sure not to fill more
than 2/3 of the Container.
3. Cut food into smaller pieces,
and place those pieces evenly
around the Blades in the Container.
5. Select the chopping speed using the
Speed-control Switch. Use the Low speed (I)
for a coarse cut and High speed (II) for a fine cut.
Note: We recommend that you always start
the chopping process with the Low speed (I).
7. Reset the Speed-control Switch to
Low speed (I).
8. Turn the Cover counter-clockwise
to detach it from the Container, and
then remove the Chopping Blades.
9. To separate the Top Cover from the
Bottom Cover for cleaning, place a
thin utensil into the small opening
located at the opposite side of the
Pulling Handle, and pull up the utensil
to detach the parts.
If the blade doesn't move freely, open the
Cover to check whether the Blade is
properly connected to the Cover. Reposition
large chunks around the Chopping Blades if
necessary.
At first, pull the cord gently to ensure it is
moving freely. Let the cord retract after each
pull. If there is resistance from hard food like
carrots, pull the cord lightly multiple times
to start the chopping process.
6. With one hand, push down firmly on the
Cover and use your free hand to pull the
cord to start rotating the Chopping Blades.
4. Place the Cover onto the Container
and turn clockwise to lock in place.
Top Cover
Botom Cover
Cover
