multicomp pro MP004561 User manual

1
RPi4 CASE, WITH HEATSINK KIT
Assembly Instructions
MP004561 and MP004562
IMPORTANT SAFETY INFORMATION
When using electronic components basic safety precautions should always be
followed.
KIT CONTENTS
WARNING: This is an electrostatic sensitive device, take precautions to
ground yourself during the assembly procedure.
ASSEMBLY
1. Take carrier plate (g) & attach stand-offs
(c&d) with screws (b).
Attach both heat block (j&l) to carrier plate
(g) with screws (n) as shown.
Peel backing paper from adhesive pads
(k&m) & stick to each heat block (j&l).
Now remove remaining backing paper.
(a) x8 M3x10 Taptite Screws
(b) x14 M2.5x5 Screws
(c) x4 12mm Stand-offs
(d) x3 8mm Stand-offs
(e) x1 Aluminium End Plate
(f) x1 HDMI Extender PCB
(g) x1 Aluminium Carrier Plate
(h) x1 Aluminium Extrusion
(I) x1 Acrylic End Plate
(j) x1 Small Heat Block
(k) x1 Small Heat Pad
(l) x1 Large Heat Block
(m) x1 Large Heat Pad
(n) x2 M3x5 Screws

2
2. Plug extender board (f) into the HDMI & USB connectors on the
Raspberry Pi board.
3. Place Raspberry Pi & extender on carrier
plate assembly & secure with screws (b) as
shown.
4. Turn board assembly over so carrier
plate is on top & slide into top slot of
extrusion (h) as shown.
5. Attach aluminium front (e) & acrylic (i) rear
plates to extrusion (h) with screws (a).
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronics Equipment
(WEEE). Any WEEE marked products must not be mixed with general household waste, but kept separate for
the treatment, recovery and recycling of the materials used. Contact your local authority for details of recycling
schemes in your area. Made in the UK. LS12 2QQ
PO Box 13362 Dublin 2
Man Rev 1.1