multicomp pro RPi3 CASE User manual

1
RPi3 CASE, Pi-BOX PRO 3
Assembly Instructions
MP004559 and MP004560
IMPORTANT SAFETY INFORMATION
When using electronic components basic safety precautions should always be
followed.
KIT CONTENTS
WARNING: This is an electrostatic sensitive device, take precautions to
ground yourself during the assembly procedure.
(a) x8 M3x10 Taptite Screws
(b) x14 M3x5 Screws
(c) x4 12mm Stand-offs
(d) x3 8mm Stand-offs
(e) x1 Aluminium End Plate
(f) x1 HDMI Extender PCB
(g) x1 Aluminium Carrier Plate
(h) x1 Aluminium Extrusion
(i) x1 Acrylic End Plate
ASSEMBLY
1. Take carrier plate (g) & attach stand-offs
(c) & (d) with screws (b).

2
2. Plug extender board (f) into the HDMI & USB connectors on the
Raspberry Pi board.
3. Place Raspberry Pi & extender on carrier
plate assembly & secure with screws (b) as
shown.
4. Turn board assembly over so carrier
plate is on top & slide into top slot of
extrusion (h) as shown.
5. Attach aluminium front (e) & acrylic (i) rear
plates to extrusion (h) with screws (a).
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronics Equipment
(WEEE). Any WEEE marked products must not be mixed with general household waste, but kept separate for
the treatment, recovery and recycling of the materials used. Contact your local authority for details of recycling
schemes in your area. Made in the UK. LS12 2QQ
PO Box 13362 Dublin 2
Man Rev 1.1