Mvotem Optics MPA-5S-4C Owner's manual

1
MPA-5/24S-4C Light Controller
Technical Instructions
The product is a 400mA four-channel constant current controller designed for
driving LED light sources, with two output channels for 5V spot light sources
and two output channels for 24V light sources, and the output of each channel
can be adjusted independently by the brightness adjustment knob, thus
realizing the adjustment of LED light source brightness.
The controller is small in size and simple in structure; the high accuracy of
output constant current ensures the consistency of illumination when the LED
light source works, and at the same time, extends the life of the LED light
source products. The design is mature, the process is reasonable, and the
quality of the selected materials is stable, ensuring a high degree of product
reliability and strong environmental adaptability.

2
1. Electrical Parameters
INPUT Voltage Range 88-264VAC
Frequency Range 47-63HZ
OUTPUT
Type constant current
Port 5V 2
Port 24V 2
Adjustment Range 0-400mA
Angle of the knob 300°
TRIGGER Mode +/-
Trigger Level 5-24V
PROTECTION Surge protection; Over current protection; Overheat protection.
ENVIRONMENTAOL
ADAPTABILITY
Operating Temperature 0 ～ 40℃
Storage Temperature -10 ～ 50℃
Others Size 135x95x40mm
Surface Spray
2. Interface description
P1 Operation panel diagram (front)

3
P2 Operation panel diagram (back)
Note:
CH1 and CH2 is 24V port, CH3 and CH4 5V port.
3. Wiring
Power Output Wire Connection：
P4 Output Connector
24V Plug in model：SMP-03V
1: (to light)
2: NC
3: - (to light)
5V Plug in model：SMP-03V
1: + (to light)
2: (to light)

4
3: NC
External Trigger Power Input Wire Connection：
P6 External Trigger
4. Operation Instruction
1. Manual Mode
CH1 to CH4 are the knobs to change the brightness of channel 1 to
4 respectively (by clockwise rotating).
2. Hardware Trigger Working Mode
MANU is manual mode, when the trigger current is 0V, the lighting
source output works, when the trigger current is 5-24V,the lighting source
output shuts down.
REMO is remote trigger mode. When the trigger current is 0V, the
lighting source output shuts down, when the trigger current is 5-24V,the
lighting source output opens.
Note：Select the "MANU" mode, trigger level is not connected (that is, 0V),
the light source is constantly on.

5
5. Structure