My Child Lars 3 in 1 User manual
Lars 3 in 1
Highchair
V1
INSTRUCTIONS:
This product conforms to BS EN 14988:2017+A1:2020
Highchair and booster: Suitable for children who are able to sit
up unaided (approximately 6-9 months) up to 36 months and
not exceeding 15kg/33lbs. Your child’s safety may be affected
if you do not follow these instructions.
IMPORTANT! READ CAREFULLY AND
KEEP FOR FUTURE REFERENCE
page 2
Safety instructions
We know that safety is of utmost concern for parents and carers of children. Whilst this
product has been developed to all of the relevant safety standards, we need your help
to maintain that level of safety and minimise the risk of a baby using this product being
harmed. Your baby should never be left alone in the highchair and all harmful objects
should be kept out of your child’s reach.
Warning: NEVER leave the child unattended.
Warning: Always use the restraint system.
Warning: Falling hazard: Prevent your child from climbing on the product.
Warning: Do not use the product unless all components are correctly tted and adjusted.
Your child’s safety is your responsibility.
Warning: Be aware of the risk of open res and other sources of strong heat, such as
electrical bar res, gas res etc. in the vicinity of the product.
Warning: To avoid injury keep your child away when assembling or adjusting this product.
Warning: Ensure the seat-lock screw is attached and correctly tightened before seating
a child in the highchair.
Warning: The tray is not designed to hold the child in the highchair. ALWAYS use the
harness.
Warning: Do not allow children to stand on the seat or footrest or climb into or out of the
highchair.
Warning: When adjusting the tray, ensure that parts of your child’s body are clear of any
moving parts.
Warning: Highchair and booster are suitable for children who are able to sit up unaided
(approximately 6-9 months) up to 36 months and not exceeding 15kg/33lbs.
Warning: Bar stool (tall stool) is suitable for children aged 5 to 10 years.
• Ensure that the locks and catches on the product are not obstructed at any time
during use.
• Do not let your child play with this product.
• Ensure the safety harness is fastened and correctly adjusted at all times.
• Do not use near stairs or steps.
• Ensure the highchair is used on a secure and level surface.
• Never carry the highchair with your baby in it.
• Do not use if any part is broken, torn or missing. Periodically check for loose or
damaged parts.
• It is recommended that the highchair is only used by babies who can sit and support
themselves unaided.
• Only use parts and accessories approved by the manufacturer. Others may render
the highchair unsafe and will invalidate the warranty.
• This highchair is designed to hold 1 child.
page 3
Your 3 year warranty
Whilst we make and test our products to the highest standards of durability there’s
always a small chance of a hiccup! Our promise is to repair, replace or refund a
MyChild product that has an identied manufacturing defect from the date of
purchase for a full 3 years thereafter at no extra cost.
However, you must register within 28 days of the date of purchase to receive the full 3
years guarantee!
To receive your full guarantee you can register your product by:
visiting https://mychild.co.uk/pages/warranty and complete the warranty form,
or by telephone on 0161 335 2508.
Welcome
Thank you for purchasing the MyChild Lars 3 in 1 Highchair.
Please read the instructions and warnings carefully before use to ensure safe and
satisfactory operation of this product.
Your child’s safety is your responsibility. If you have a query with this product or require
replacement parts, please contact the MyChild Helpline on 0161 335 2508.
Lay out the parts on a soft level surface and compare to the part/xings checklist
below. Do not discard any packaging until you are sure that you have all the parts.
WARNING! Assembly by an adult. Keep away from children until fully assembled. Keep
children clear during assembly as pack contains small parts which may present a
choking hazard.
page 4
Contained in your carton are:
NoPart Qty
ASeat shell 1
BStool top/seat base 1
CArmrest 1
DTray & snack tray 1
EFootrest 1
FFootrest supports 2
GFootrest screws 4
HSeat-lock screw 1
IFront legs 2
JRear Legs 2
KFront Feet 2
LRear Feet with crossbar &
wheels
1
MLeg side-braces 2
NAllen bolts (for side-braces) 4
OBooster seat feet (plus straps) 4
PBackrest strap 1
QAllen key 1
Parts Checklist
B
C
D
G H
I J
K L M
NO
Q
P
A
E
F
L R
R
L
page 5
1. Attach the two front legs (I) (legs with long slots) to the stool top (B) as shown. The left
leg (L) goes in the front left socket and the right leg (R) in the front right socket. Press in
button (i) at the top of each leg and slide the legs into their sockets on the stool top,
ensuring the legs ‘click’ into position.
2. Attach the two rear legs (J) (legs with NO slots) to the stool top (B) as shown. The left
leg (L) goes in the rear left socket and the right leg (R) in the rear right socket. Press in
button (A) at the top of each leg and slide the legs into their sockets on the stool top,
ensuring the legs ‘click’ into position.
Assembling the highchair
L
L R
R
R
Top
Top
Bottom
Bottom
L
L
i
I
B
B
J
i
R
page 6
Assembling the highchair (continued)
3. Attaching the front feet:
Press in button (i) and slide the feet (K)
on to the front legs. Ensuring each foot
‘clicks’ into place.
4. Attaching the rear feet:
Press in button (i) and slide the feet (L)
on to the rear legs. Ensuring each foot
‘clicks’ into place.
5. You should now have something
resembling the image shown above.
WARNING! The item is still only partly
assembled and is not stable. Do not
apply ANY weight to the item.
6. Attach leg side-brace (M) using two
Allen bolts (N). Tighten the bolts using
Allen key (Q). Attach the remaining
second leg side-brace in the same way.
K
L
i
i
M
NN
Q
Q
page 7
Assembling the highchair (continued)
8. Attaching the footrest:
Place the assembled footrest between
the highchair’s front legs and secure using
two footrest screws (G).
Note: The footrest has four height position
settings. Use the uppermost setting for
smaller children and lower the footrest
when the child outgrows the height
setting.
9. You should now have an assembled,
and ready to use bar stool, suitable for
children aged 5 to 10 years.
Continue with remaining steps to
assemble the complete highchair for
children aged 6 months to 3 years.
7. Assembling the footrest:
Attach the footrest supports (F) to the footrest (E) using two footrest screws (G).
IMPORTANT: Check that the assembled footrest and supports resemble (g 1) when
viewed from the side and NOT (g 2).
Note: Move the footrest supports in, towards each other, for the uppermost footrest
position and for use with smaller children.
Move them outwards, away from each other, for the lowermost footrest position and
for use with taller children.
E
F
F
G
G
g 1 g 2
G G
page 8
Assembling the highchair (continued)
10. Attaching the highchair seat:
Insert the four pins on the underside of the seat shell (A) into the four keyhole slots on
the upper surface of the stool top (B) and push the seat back into the stool top to lock
the four pins in place.
11. Secure the seat (A) to the stool top (B)
using the seat-lock screw (H).
To remove the seat: Unscrew seat-lock
screw (H), press release button (i) and
slide the seat back off from the stool top.
click
A
B
B
A
H
i
page 9
Assembling the highchair (continued)
12. Attaching the armrest:
Hold the armrest (C) at an angle as shown and insert the armrest so that the buttons (i)
insert into the oval holes on each side of the seat.
13. Check the buttons on each side of
the armrest are inserted and push them
in if not.
14. Whilst pulling the lever on the front-
underside of the seat, push the armrest
down so that it locks into the seat.
IMPORTANT! Always keep the armrest
attached and xed in position whilst using
in the highchair mode.
click
g 1 g 2
i
page 10
Assembling the highchair (continued)
15. Attaching the tray and snack tray.
Whilst pulling the two levers on the underside of the tray outwards, place the tray onto
the armrest and slide the tray along into position. The tray will click into place when
properly located.
16. The removable snack tray can be
removed by levering the tray with your
nger as shown. To reattach: simply click
it back on.
17. The highchair is now fully assembled.
page 11
1. Place the crotch strap between your
child’s legs and slide the shoulder strap
clips onto the waist strap clips.
2. Insert the harness clips into the buckle,
making certain your child’s ngers are
clear. Adjust the sliders (i) on the waist
and shoulder straps so that the harness ts
snugly.
3. Releasing the 5-point harness:
Press the harness release button (ii) and
slide the buckle sections apart.
WARNING: Always use the ve-point harness.
WARNING: When using the highchair at a table ensure the child cannot push against
the table or any other surface as this could result in the highchair tipping over.
ii
ii
i
Securing your child using the harness
page 12
Assembling the booster seat
1. Press in button (i) and slide the booster-seat feet (O) into the sockets on the seat
base (B), ensuring each foot ‘clicks’ into place. Attach all four feet and check that
they are all properly connected.
IMPORTANT: Check that the assembled feet and seat base resemble (g 1) when
viewed from the side and NOT (g 2).
g 1 g 2
O
B
O
2. Feed the two ends of the backrest
strap (P) through the harness slots in the
seat base (B)
3. Place the partly assembled booster
seat on a suitable adult chair.
P P
B
page 13
Assembling the booster seat (continued)
4. Wrap all four “foot-straps” under the
adult chair and buckle them together
ENSURING you DO NOT cross the straps.
Wrap the backrest strap around the back
of the adult chair and buckle it together.
Pull and tighten all straps to prevent
as much movement as possible. If the
booster seat moves around too easily
then it may not be suitable for use on the
adult chair and you should nd a better
suited adult chair.
WARNING! DO NOT place anything
under the booster seat and on the adult
chair such as cushions or fabrics as they
may cause the booster seat to become
unstable.
click
clickclick
A
B
5. Insert the four pins on the underside of the seat shell (A) into the four keyhole slots on
the upper surface of the seat base (B) and push the seat shell back into the seat base
to lock the four pins in place.
click
page 14
Assembling the booster seat (continued)
6. Finally secure the seat shell (A) to the
seat base (B) using the seat-lock screw
(H).
H
B
A
page 15
Care and maintenance
• Avoid placing the highchair in direct sunlight for extended periods. Over time this
will cause the materials and nish to fade.
• Clean the seat fabric using either a dry or damp cloth. Do not soak the seat fabric
or attempt to wash by hand or by machine.
• DO NOT Iron or expose the seat fabric to strong heat.
• The top food tray can be placed in a dishwasher or washed by hand using a mild
detergent.
• The bottom food tray is NOT dishwasher safe. It should be wiped clean only, using a
damp cloth and mild disinfectant.
• The highchair frame can be cleaned using a damp cloth with warm water and a
mild detergent.
• A mild disinfectant can be used if desired. Stubborn marks maybe removed with a
NON-abrasive cleaner.
• The highchair must be dried thoroughly before using or storing.
• NEVER clean any part of the highchair with abrasive, ammonia based, bleach
based or spirit type cleaners.
Table of contents
Other My Child High Chair manuals
