MyBeerTap GFS-B6 User manual

Instruction Manual of GFS-B6 My Beer Tap
For Video Set Up Guide Visit
www.MyBeerTap.com
 Applied for canned beer in height 330ml 350ml and 500ml
 Insulation design
 Easy to clean after use
 Perfect for applying to the family gathering, hotels, bars, clubs.

Components
① Pull-push Rod
② op cap
③ Main Body
④ Pedestal
⑤ Base
⑥ Beer output

How to Operate
1. ake off the top cap from main body by anticlockwise turning.
2. Open the battery cover to fill two pieces AA battery and then close the cover
by fixing the screw.

3. Put the battery-filled top cap back to the main body by clockwise turning. It’s
fixed when line marks on top cap and main body are in a line.
4. ake off the main body from pedestal by anticlockwise turning.

5. Open the canned beer and put it into the pedestal.

6. At last, put the main body back to pedestal by clockwise turning. It’s fixed
when line marks on main body and main pedestal are in a line.
7. Put a cup on the base platform and enjoy the beer bubble by below function
instructions:
1) Pull the pull-push rod, normal beer comes out; Push the rod, bubble comes
out. Cooling beer brings better taste and result;
2) ake off the insulation from the main body if beer heat preservation is not
needed.

SPECIFICATIONS
Power Source 1.5V, 2pcs AA alkaline batteries ( not included )
Operating Ultrasonic Vibration
Exclusive product for use with canned beers ( 330ml/350ml/499ml).
Material ABS, Silicone Gel
Working current 260mA
Maintenance
1. ake off the silicone gel tube from the main body for water cleaning if
needed;
2. ake the base for water cleaning if needed;
3. ake off the battery when not in use;
4. his appliance contains electronic component, please do not immerse the
full unit into water, especially the top cap;
5. Do not disassemble the appliance by yourself. Contact with an expert when
needed.