MYDLINK DCS-8330LH User manual

Smart Full HD Wi-Fi Camera
Quick Installation Guide
DCS-8330LH
with built-in smart home hub
快速入門指南

1
DCS-8330LH
ENGLISH
Smart Full HD Wi-Fi Camera
with built-in smart home hub
Quick Installation Guide
Power Adapter
2 x Screws
2 x Wall Anchors
Alignment Sticker

DCS-8330LH
2
ENGLISH
1Download the App
Search for mydlink and download the app.
Note: This product is incompatible with
other mydlink apps such as ‘mydlink Home,’
‘mydlink Lite,’etc.
mydlink

3
DCS-8330LH
ENGLISH
2Log In
Sign In or Sign Up for a mydlink account.
mydlink Lite users may sign in with the
same account.

DCS-8330LH
4
ENGLISH
3Add the Device
Tap the menu button then tap Add
a Device. Scan the Setup Code on the
device, then follow the app instructions.

5
DCS-8330LH
ENGLISH
Device Information
i
LED Behavior
Connected to Wi-Fi and mydlink
Status LED
Powering on / Resetting
Pairing with a mydlink Smart DIY device
Ready for set up / Disconnected
Upgrading firmware - do not power off

DCS-8330LH
6
ENGLISH
Place the camera at least 2 meters from the ground. The
viewing distance for Person Detection is between 2 - 5
meters.
Placement
2 m
69o
2 m
min
120o
5 m
max

7
DCS-8330LH
ENGLISH
Mounting
1/Stick the alignment sticker
where you would like to
place the camera.
2/Use a 6 mm drill bit to drill
two 25 mm deep holes as
indicated on the alignment
sticker.
3/Hammer in the plastic wall
anchors to support the
screws.
2.6~3.0mm
2.6~3.0mm
2.6~3.0mm

DCS-8330LH
8
ENGLISH
Mounting
4/Twist the screws into the
anchors, leaving the tops
of the screws exposed
from the surface. Do not
over tighten the screws.
5/Align the mounting holes
on the bottom of the
camera with the screws.
Slide the camera down to
lock it into place.
6/Twist the camera to your
desired position. Go to the
settings in the app and
enable Invert Image if the
image is upside down.
2.6 ~ 3.0 mm
2.6~3.0mm
2.6~3.0mm