
Safety instructions
General instructions
•If the units are combined with units from other
manufacturers, they must also be considered.
•For proper installation, be sure tousethe correctcutout
dimensions asspecified foryour specific model number.
•For installation, itisrecommended that you apply a
silicone seam to the back of the frame before installing
it. (Not included in the product scope)
•Some models mayinclude an additional owner’s manual.
Assembly
Caution: Please observe the assembly
instructions and specifications of this manual before
installing this product.
For proper installation, be sure to use the
correct cutout dimensions asspecified for your model
number. Locate your model on the following pages for
dimensions, and reference the cut-outdiagram ofyour unit
for proper orientation.
For door
Slide the unit into the opening of the island and screw
the unit at the intended points using suitable screws (not
inclu- ded in the product scope).
Install handles
For Drawer:
Before installing your drawer, remove the drawer from its
base by completely pulling it out. Release the drawer from
the drawer slides by pressing the black lever down on the
right side, and up on the left side. Then pull outwards on the
drawer until it comes free of the runners.
Releasing drawer from sides
1. To properly support the weight of your drawer, it is
necessary to provide a secure, level surface in the rear of
the cabinet (See below). Be sure that the height of this
rear support is the same height as the front opening
support, so that your drawer sits level. Releasing drawer.
3. To reinsert the drawer, completely pull out the slide rails
and place the drawer on the rails, and then close the
drawer. Open the drawer to verify that it has locked in
place.
Drawer
front
Drawer
support
Side view
Door jamb