mysoda GLASSY User manual

1
InstructionManual
SPARKLING
WATER
MAKER
GLASSY

2
English
Français
Deutsch
Suomi
Svenska
Dansk
Norsk
Dutch
Italiano
Polski
Magyar
Slovenčina
Čeština
Slovenščina
Español
Português
3
8
13
18
23
28
33
38
43
48
53
58
63
68
73
78

3
ENGLISH
Read the instructions in this manual carefully before using the sparkling water maker. Always follow the instructions and safety
precautions. Using the device against the instructions and precautions may result in damage to the device and personal injury.
Keep this manual for yourself and other users of the device. The following warnings apply to the use of the sparkling water maker,
the water bottles and the carbon dioxide (CO2) cylinders used within it.
1. This product is not designed or intended for use by
children under 12 years of age. Adult supervision is
necessary when the device is used by children.
2. This appliance is not intended for use by persons
(including children) with reduced physical, sensory, or
mental capabilities, or lack of experience and knowledge,
unless they are closely supervised and instructed
concerning use of the appliance by a person responsible
for their safety.
3. WARNING Do not use the appliance if you notice or
suspect a defect or damage. Contact your dealer,
importer or manufacturer.
4. Do not make any modifications or repairs to the device
and accessories. Repairs may only be made by authorized
Mysoda service personnel.
5. Never remove the water bottle during carbonation. Do
not discharge a CO2 cylinder unless a Mysoda water
bottle is attached to your sparkling water maker.
6. Only carbonate drinking water. Add flavours after
carbonation.
7. Always place the device on a level, stable, and water-
resistant surface.
8. The device must always be in an upright position when
used.
9. Do not immerse the device in water and do not clean it
during use.
10. Only use the device when a filled bottle is inserted.
11. Never attempt to carbonate an empty bottle with CO2.
12. Before each use, inspect that the CO2 cylinder is firmly
attached to the device.
13. Never transport the device with a full water bottle
attached to it.
14. Never transport the device with the CO2 cylinder
attached to it.
15. Use only Mysoda water bottles with this device.
16. Never use sharp tools, abrasives or chemical cleaners
to clean the device. For cleaning, we recommend a mild
hand dishwashing detergent and a soft damp cloth.
17. The device warranty is only valid for non-commercial use.
IMPORTANT SAFEGUARDS
WARNINGS FOR THE DEVICE AND THE USE OF IT
WARNINGS FOR THE PLASTIC WATER BOTTLES
WARNINGS FOR THE GLASS WATER BOTTLES
WARNINGS FOR CARBON DIOXIDE CO2 CYLINDER
18. Do not place plastic water bottles in a freezer.
19. Do not store plastic water bottles in a dishwasher or in
hot water.
20. Do not store plastic water bottles close to any heat
source, such as an oven or stove or inside a hot car.
21. Check the expiration time on the water bottle before
using it. The expiry date is indicated in the form of
month / year. Do not use an expired bottle after the last
month of use.
22. Do not use the plastic water bottle if deformed,
scratched, or discoloured, or if the expiration date has
passed.
23. In the above cases, replace the plastic water bottle with
a new one.
24. Do not wash plastic water bottles in a dishwasher or
in hot water. Never use brushes, abrasives, or chemical
cleaners. Hand wash bottle with mild detergent and
warm water. If necessary, use a soft bottle brush.
25. Do not place glass bottles in a freezer.
26. Do not expose to extreme temperature changes like
adding hot water in a cold glass bottle.
27. Do not use a glass bottle, other than the original Mysoda
glass bottle that is suitable for Mysoda Glassy.
28. Do not wash glass bottle caps in a dishwasher or in hot
water.
29. Do not use the glass bottle if cracked, chipped or
damaged in any way.
30. In the above cases, replace the glass bottle with a new
one.
31. In a rare cases that your glass bottle breaks during
carbonation inside your device, do not open the device.
Any broken glass particles will be safety contained inside
the device. Please contact your local Mysoda customer
service for assistance.
32. Inspect the CO2 cylinder before use. If the cylinder or the
valve attached to it is damaged, do not use it, but contact
your dealer, importer or manufacturer.
33. Do not attempt to modify, puncture or incinerate the
cylinder.
34. Do not throw the cylinder or cause it to fall.
35. Do not store the CO2 cylinder in a freezer.
36. If the CO2 cylinder is colder or warmer than room
temperature, it must be gradually brought to room
temperature. Do not place it in the freezer or on a heat
source to speed up the process.
37. WARNING Food Safety Hazard:
• Use only food / beverage grade carbon dioxide
cylinders purchased from an authorized dealer.
• Never use a carbon dioxide cylinder intended for
non-food use.
• Never use any adapter that permits use of
non-beverage grade CO2 or non-beverage CO2
cylinders.
38. WARNING CO2 cylinder contents are under pressure.
39. WARNING Explosion Hazard. Always store CO2 cylinders
in a cool, dry place, away from any type of heat exposure.
Exposure to heat can cause cylinder pressure to build
and release CO2 gas unexpectedly.
40. WARNING Do not touch the cylinder if CO2 is being
released; wait until all the CO2 is discharged and the
cylinder has come to room temperature. In the event of
a leak, ventilate the house or apartment well. If you feel
unwell, contact your doctor.
41. WARNING Frostbite injury risk. Rapid depletion of CO2
gas can cause skin to freeze.

4ENGLISH
7. Carefully insert back cover back to the
device.
6. Gently tilt the cylinder holder towards you
and install the CO2 cylinder by screwing it
clockwise. Attach the cylinder firmly
enough, but do not tighten too much.
5. Remove the seal and cap from the
CO2 cylinder.
Mysoda Glassy, as well as all the other Mysoda machines, use the most common
carbon dioxide cylinder with screw-in system, so that you can always easily find
an exchange for your empty cylinder at your nearest store.
4. Unscrew the black thread protective
cap on the top part of the device body.
3. Remove back cover from the device.2. Remove the water bottle by pulling the
bottle and carbonation nozzle towards
yourself, and then unscrew it (one quarter
clockwise).
1. Open the device door by pushing
“Pressure Release”-button (•) at the
back of the machine top. Let the door
open on its own, do not force it.
Pressure release button
/ door opening button (•)
Device door
Bottle cap
Max fill level
Carbonating button (• • •)
Glass bottle /
Reusable plastic bottle
PARTS AND FEATURES
INSTALLING THE CO2 CYLINDER
COMPATIBLE CO2 CYLINDERS
SPARKLING WATER MAKER
BEFORE THE FIRST USE: Hand-wash the water bottle with
lukewarm water and hand dishwashing detergent. Rinse well
and wipe outside with a soft cloth to dry. WARNING: Never
wash plastic water bottles or any bottle caps in a dishwasher or
in hot water. Harsh chemicals will damage the water bottle.
!
1L PLASTIC BOTTLECO2 CYLINDER
Usage tip: A used CO2 cylinder can be exchanged by a CO2
cylinder dealer near you. Return the empty cylinder so that you
only pay for the gas refill.
Usage tip: Keep a spare CO2 cylinder in your home so that you
can replace it as soon as you run out of gas. Extra cylinders are
available from CO2 cylinder dealers near you.
After the CO2 cylinder is empty, replace the CO2 cylinder in the
same way as the first time you installed the cylinder.
1L GLASS BOTTLE

5
ENGLISH
SPARKLING WATER MAKER
PLASTIC WATER BOTTLE GLASS BOTTLE
CO2 CYLINDER
To clean your sparkling water
maker, wipe with a damp cloth.
Do not immerse the device in
water. Do not use any solvents or
abrasive cleaners, since this could
damage the surface.
Rinse the water bottle with clean water
after each use. Wash the bottle by
hand with hand warm water and hand
dishwashing detergent. Rinse well. Wipe
the outside with a soft cloth to dry.
Rinse the water bottle with clean water after each
use. Wash the bottle by hand with warm water
and hand dishwashing detergent. Rinse well.
Wipe the outside with a soft cloth to dry. Mysoda
glass bottles can also be washed in a dishwasher.
NOTE! That cap should not be washed in a
dishwasher.
A used CO2 cylinder can be refilled by your Mysoda
dealer. Return the empty cylinder so that you only
pay for the gas refill.
CARE AND CLEANING OF YOUR DEVICE
HOW TO MAKE SPARKLING WATER
1. Fill the Mysoda water bottle of
your choice with cold water up to
the filling line.
2. Open the device door by pushing
“Pressure Release”-button (•) at
the back of the machine top. Let
the door open on its own, do not
force it.
3. To insert the water bottle,
make sure that the device is
in a fully upright position and
the bottle quick-lock is angled
forward. Then insert the bottle
in quick-lock and turn one
quarter anti-clockwise to lock it.
Push gently the bottle towards the
device to a vertical position.
4. Close the door by sliding it to the
right, now it is in closed position.
Always remember to close the door
as the device won’t carbonate if the
door is open. As a safety feature,
the device will just automatically
release the pressure if the door is
open while you try to carbonate.
5. Now you can start to carbonate
the water by pushing the
carbonating button (• • •) 2–3
times. Stop when you hear a
hissing sound.
6. Open the device door by
pushing “Pressure Release”-
button (• ) at the back of the
machine top. Let the door open on
its own, do not force it.
7. Pull the bottle towards yourself
and turn it one quarter clockwise
to release the bottle.
8. Enjoy your carbonated water or
add desired flavor.