Myzone Stick PC User manual

SOP
NEW INSTALL

STEP ONE:
Remove MYZONE®Stick from packaging.
STEP TWO:
Connect power cable to the power port on the
side of MYZONE®Stick and to a power outlet.
STEP THREE:
Connect the Ethernet USB HUB to the MYZONE®
Stick through the USB 2.0 Port.
STEP FOUR:
If you are using a wired internet connection, please connect
Cat 5 internet cable to wall jack and LAN port on the USB HUB.
If you are using a wireless internet connection please
follow instructions on STEP 11to setup the wireless
connection after completion of other steps.
STEP FIVE:
Remove MYZONE® Receiver from the packaging.
STEP SIX:
Connect MYZONE® Receiver to any one of the 3 USB ports.
STEP SEVEN:
Attach Receiver to wall 2-2.5m high. (Please refer to
MYZONE® Receiver Setup Document)
Power Port
USB Hub Port
Ethernet USB Hub
Wired internet connection
3 USB ports
MYZONE Reveiver
MYZONE
®Stick Installation Guide
IF YOU HAVE PROBLEMS AFTER FOLLOWINGTHIS GUIDE CONTACT US ON [e-mail]

STEP EIGHT:
Remove the battery cover from the back of the Wireless Mini Keyboard to
expose the USB receiver dongle. Remove the dongle and plug into one
of the USB ports on the USB hub. Replace battery cover and turn keyboard
on by sliding power switch on the top left shoulder of the keyboard. The
supplied cable is just for charging the keyboard and doesn’t allow data
transfer / communication. NB. Each keyboard will only work with the
corresponding receiver so it may be worth marking the keyboards if you
have more than one zone.
STEP NINE:
Plug the MYZONE®Stick into one of the HDMI ports on your
TV /Display and power on the MYZONE®Stick by pressing the
power button if not on already.
STEP TEN:
The MYZONE®software will auto start.
STEP ELEVEN:
If you are using a wireless internet connection rather than
a wired connection please follow these steps to connect to
your wireless network:
Hit Alt and F4 on your bluetooth keyboard
to exit to the desktop.
Click the wireless network symbol, select your wireless
network, click connect and enter your Wi-Fi password.
MYZONE
®Stick Installation Guide
Bluetooth mini keyboard
Power button
IF YOU HAVE PROBLEMS AFTER FOLLOWINGTHIS GUIDE CONTACT US ON [e-mail]

STEP TWELVE:
If you need MYZONE®to be displayed on multiple screens
using a single MYZONE®Stick, you will need a HDMI Splitter .
(Please note that the HDMI Splitter is not provided by
MYZONE®and will have to be sourced by the club)
STEP THIRTEEN:
The MYZONE®Stick has to be plugged into
the Input HDMI Socket in the HDMI Splitter.
STEP FOURTEEN:
The output HDMI ports will be connected to theTV/Display to
project the MYZONE®display. (Please note HDMI Cables are not
provided by MYZONE® and will have to be sourced by the club)
STEP FIFTEEN:
Please plug the power source to the HDMI Splitter.
STEP SIXTEEN:
Once theTV /Displays are set on the correct input mode and
when the MYZONE®Stick is switched on, the displays should
come up on all the connected displays.
STEP SEVENTEEN:
Please ensure that the indicator lights for all outputs on the
splitter are working to ensure signal is being sent.
STEP EIGHTEEN:
The connections will need to be switched on in the below order
to get the display working on all the connected displays.
•TV /Monitors
•HDMI Splitter
•And then the MYZONE® Stick
IF YOU HAVE PROBLEMS AFTER FOLLOWINGTHIS GUIDE CONTACT US ON [e-mail]
MYZONE
®Stick Installation Guide
Input HDMI
HDMI Ports