Nado O10 User manual

instructions O10

LANGUAGES
ENGLISH 11

PART LIST
04
1
5
6
7
3
8
10
2
4
9
11
12
13

INSTRUCTIONS
05
CLICK!
1a
1c
1b

INSTRUCTIONS
06
1d
1g
1e
1f

INSTRUCTIONS
07
2a 2b
9 kg-18 kg (76-105cm) 15 Kg - 36 kg (105-135 cm)

INSTRUCTIONS
08
2c 2d

INSTRUCTIONS
09
3d3a

INDEX
10
5c

11
12
14
15
16
17
18

12
When the device is used in combination with an adultsafety-belt
to be used by means of the following wording: Only suitable for
htiwdettifselcihevdetsilehtniesu 3 point safety-belts, approved
to ECE Regulation No. 16 or other equivalent standards.

13
It shall be recommended that any straps holding the restraint to
the vehicle should be tight, that any straps restraining the child
should be adjusted to the
child's body, and that straps should not be twisted.
The importance of ensuring that any lap strap is worn low down,
so that the pelvis is firmly engaged, shall be stressed.

14

Installation from 9 kg up to 18 kg (76-105cm):
1a. Slide the Isofix anchors (11) to their maximum length by turning
the lever (13). Do this on both sides of the seat.
1b. Open the cover (4) and take the top tether connector out (14).
1c. Connect the Isofix anchors until you hear them click into place. The
display window on the button (12) will turn from red to green.
1d. Push the seat as far back as possible. Make sure that both Isofix
are in the same position once you have pushed
the seat back.
1e. Connect the Top Tether in the anchor point inten-
ded for this in the vehicle marked with the symbol:
1f. Lastly, tighten the strap of the TT system until the green signal is
displayed on the indicator. The strap should go over the backrest of
the vehicle seat. If necessary raise the headrest or remove it to enable
correct installation.
The ISOFIX visual indicators show whether the connector is open or clo-
sed. The connector may be closed without being secured in the ISOFIX
anchor. Please make sure that the connectors are correctly fastened into
the anchor points of the vehicle by pulling the seat once it has been
installed.
To detach the seat follow the same steps in reverse:
1g. Move the button (12) to open the connector and release the
anchors.
Installation from 15 kg up to 36 kg (105-135cm):
Follow the same steps as before, , and . In this case you1a, 1b, 1c 1d
should not connect the Top Tether.
There is also the possibility of installing the child seat only with the
car seat belt.
15

16
2c
3a.Loosen the harness by pressing the button and pulling the diagonal
part of the harness straps.Unfasten the buckle by pressing the red
button. Move the ends of the buckle to each side of the seat so you
can put the child in the seat.Position the child in the seat and put
the strap over him on the both sides, and then fasten the buckle.
3b.Tighten harness by pulling the lower strap A To get the child
out of the seat follow the same process in reverse.

2d
17

18



2