NAMENE WATU User manual

Get ready
to build your
Watu
Assembly instructions

Components list
Watu solar light in 11 pieces
1Front case
2Back case
3PCB
4 Baery
5a Buon sticker
5b 4 screws
5c 2 small screws
5d PH1 key
6 Stand (not illustrated)
7 Headband (not illustrated)

1b Screw in the PCB
HINT Use the PH1 screwdriver
Step 1
Connect the baery to the PCB electronics
1a Connect the baery to the PCB
HINT Make sure you connect to
the bigger connector!
1 Front case
3PCB
4 Baery
5c 2 small screws
5d PH1 key

Step 2
Connect the back case wire to the PCB
2b Connect the PV module
to the PCB
HINT Make sure you connect to
the smaller connector!
2Back Case

Namene Solar Lights Ltd.
51 Holland Street, London, W8 7JB, UK
Step 3
Close the case with the screws
3b Close the case with the screws
HINT Use the PH1 key to tighten the screws!
5b 4 screws
5a Buon sticker
5d PH1 key
3a Close the cases. 3c Apply the sticker to the front
HINT Make sure you stick it down really tight!