Shanghai Nanhua Electronics Co., Ltd Tel：+86 021-39126868 Fax：+86 021-39126868ext 808/818 Web：www.nanhua.com E-mail：sales@nanhua.com Add: Building 9, No.
1755Wenbei Rd, Jiading district Shanghai 201802
All rights reserved by Nanhua,without the written authorization of the Nanhua, any part thereof shall not be reproduced or transmitted in any form.
FR15 series S
nchronizin
Control Box
FR15
-
1-V10
2 /2
FR151U setting
FR151W setting
Accessory：photocell
PJ003
Product details
FR151U side
FR151W/FR152W
Connection
FR151U steady burning/flashing setting
• Open the cover board on control box. There are a black button and red dial switch inside it.
• Steady/flash switchover：Slide red dial switch to according lamp.
Figure terminal---flash
Otherwise--------steady
After setting over, please confirm it by pressing black button.
FR151W/FR152W connection
• Power terminal connetion,please see the following diagram：
• Following is diagram for aviation light connction :
If control box has disturbance switching funciton, Lamp1 is lead light, Lamp2 is standby.
• Following is diagram for alarm connction.
• Following is diagram for photocell.
FR151W/FR152W installation and operation
• Installation：
Using 4 pcs of M10 stainless steel screws to fix on smooth surface with enough mechanical
strength.
• Manual/Automatic switchover：
Please see the following diagram. When the contrl box is under Auto state, it will turn off the light
at the daytime and turn on the light at the night time:
• Steady burning/Flashing switchover, flashing frequency setting：
When the two dial switches are under ON state, aviation light is steady burning. If not, aviation
light is flashing. Flashing frequency 30.40.50.60FPM is adjustable. Please set frequency as following
diagram.（FPM = FLASH PER MINUTE）:
FR151W/FR152W indicator light
• Power：Power supply indicator；Manual：Manual indicator；Auto：Automatic indicator
• Light n Fault：Aviation light fails；Light n ok：Aviation light works normally.
Notice
• The controlled aviation lights are the voltage test type, only when the aviation light inside power
fault will output alarm, suggest to used for not high required test precision.
• Make sure cut off power before connection with wire.
• Don’t open any part of the products when operation.
Setting here
Open the
cover
