Napoleon P600 User manual

Burner Removal Instructions For Napoleon P600 Model Grills
Removal of a burner must be performed by a qualified service person.
N415-0064 APR 08/08
Ensure that the
valve properly
enters the
mouth of the
burner.
1. Turn off and disconnect the gas supply to the grill. Remove
warming rack, cooking grids & sear plates.
2. Removecontrolknobsfromgasvalvesanddisconnectthe
wiresfrom the igniter located onthe underside of the control
panel.
3. Removethe1/4” hex heads screws (2)locatedon the lower
frontcornersofthe control panel.
4. Remove the side shelves by removing the #14 x 1/2” screws
(2)fromtheundersideofbothshelves.
5. Lift the shelves away from the control panel. Lift the control
panelupandoff.
6. Disconnect the gas supply hose from the manifold as well
astherearburnerfeedtube,thenremovethe3/8”manifold
mountingscrews (3) from the insideof the grill base. Remove
themanifoldassembly.
7. Removethe1/4” hex head screw (1)locatedin the centre
backofeach U shaped burner. Removetheburner shields.
Note: For re-installing, the screw can be started through the
burner into the back wall before fitting the slotted opening of the
burnershield over the screw,behind the burner.
8. Theburnerscannowberemoved by pulling each assembly
forwardslightly,thenmovingtheburnerupwardsandback,
allowing the burner to clear the holes in the front of the base.
Reversethisprocedure to re-install. Ensure that the burner
carryoverportsareontheundersideoftheburners.
7. Re-installthemanifoldensuringthatthevalveendsproperly
engagethemouthof the burners. Re-connect the rear burner
feed tube and the gas supply hose. Turn on the gas supply,
then check all joints for leaks using a 50/50 soap and water
mixture. See leak testing instructions in the manual or on the
webatwww.napoleongrills.com.
8. Reassemblealltheremainingcomponents.
Crossover ports at bottom of burner.