National Office Furniture Karid User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Karid™ Assembly Instruction
Required Tools
•4mm Hex Key Wrench
(Included)
Package Contents
Qty.
3
•Arm/Back frame
assembly
•Aluminum base
•Gas lift cylinder
•Seat/Control assembly
Product Line
Karid™ Conference Chair
1
Assemble units as described herein only. All screws and bolts
must be tightened securely and checked periodically after
assembly. Failure to assemble or to secure parts properly may
result in assembly failure and personal injury.
Figure A
•Hardware Kit:
•M8x16mm round
head bolts with
flat washers
•Hex Key Wrench 1
!
•Set of five casters 1
1
1
1
1
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part #3474908
Rev ,A
Printe in U.S.A
© 2022 Kimball International, Inc.
Insert 5 casters into the aluminum base as shown in Figure A.
Figure B
2Orient the gas lift cylinder as shown and insert the larger end of
the cylinder into the hole in the center of the base. Figure B.

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Karid™ Assembly Instruction
4
Figure D
Carefully position the seat assembly over the gas lift cylinder,
aligning the hole in the seat control with the top, smaller end
of the cylinder. Press the seat assembly onto the cylinder
then sit on the seat to completely mate the components
together. While seated, actuate height control lever and
remove weight from chair to adjust chair up to comfortable
sitting height. Figure D.
Assemble units as described herein only. All screws and bolts
must be tightened securely and checked periodically after
assembly. Failure to assemble or to secure parts properly may
result in assembly failure and personal injury.
!
3Place the upholstered seat/control assembly upside down on an
elevated flat surface. Position the arm/back frame assembly on the
bottom side of the seat control metal bar as shown in Figure C.
Align the 3 threaded holes in the metal J bar of the upholstered
back with the holes in the control metal bar. Using the hex wrench
provided secure the back to the control with three M8x16MM
round head bolts and three flat washers. Figure C.
Figure C
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part #3474908
Rev ,A
Printe in U.S.A
© 2022 Kimball International, Inc.