Native Trails Chalet Table User manual

Table Installation Instructions
Chalet Table
General Instructions
Questions? Call us at [phone] or send us an email at [email protected]
Hardware:
3x Large Bolt (3")
6x Small Bolt (1.5")
•Remove all parts from the box and lay out on a soft, dry surface such as cardboard
or carpet, to protect finish and ensure that no pieces are lost.
•Do not throw away any packaging materials until assembly is complete.
•TABLE COMPONENTS ARE HEAVY - EXERCISE CAUTION WHEN LIFTING.
TWO PERSON LIFT IS REQUIRED FOR TABLE TOP.
Materials Included:
Support Bottom
BLegs (3)
C
Support Top
ATable Top (in separate crate)
D
Tabletop Hardware:
4x Lag Bolts or
Lag Screws or
6x Washers
6x Lock Washers
9x Washers
9x Lock Washers
Allen Wrench

Table Installation Instructions (continued)
Chalet Table
3. Flip assembly upright and and tighten bolts holding support top
(A) to legs (C) using the supplied Allen Wrench (5)
Place the table top upside down on a soft surface. Flip the assem-
bled table base upside down and place on the tabletop lining the
holes up on the base with the holes in the table top. Attach the
top to the base using 6 x Lag Screws (6) and 6 x Washers (3) and
6 x Lock Washers (4) with 3/16 wrench (not provided).
or
1. Flip assembly upside down on a soft surface.
Insert Bottom Support (B) by matching up the wooden pegs in the
support with the holes in the legs as shown in the diagram. Make
sure the bolt holes in the Bottom Support (B) are facing up
(towards you) when inserting. Attach the bottom support to the
legs using 3 x Long Bolts (2) and 3 x Washers (3) and 3 x Lock
Washers (4) with supplied Allen Wrench (5) as shown
in the diagram.
2. Attach Support Top (A) to three legs (C) using 6 x small bolts (2)
and 6 x Washers (3) and 6 x Lock Washers (4) with supplied Allen
Wrench (5) as shown in the diagram.
Do not completely tighten the bolts until Step 3.