Natural Bed Company Camden Series User manual

CAMDEN COLLECTION
ASSEMBLY INSTRUCTIONS

THESE ASSEMBLY
INSTRUCTIONS APPLY
TO THE FOLLOWING
MODELS:
• Camden
• Hoxton
• Carnaby
• Plimlico
FITTINGS FOR CAMDEN COLLECTION
2X
LONG
HEADED
BOLTS
2X
BOLTS
8X
DOWELS
1X
SPANNER
4X
NUTS
4X
HALF
MOON
WASHERS
1.
Feed the long headed bolts in from the back of the legs on the headboard
Screw in the bolt through the internal threaded insert nut.

2. 3.
Screw in the bolts as illustrated to the bed footer.
Slot in the 8 dowels to the side rails as illustrated.
(Tap in with a rubber mallet if required).

4.
4x
5.
Locate the side rails on the bolts and secure using
the washers and nuts, tighten using the spanner. Slot in the centre rail.
* Please note single bed bases (75cm & 90cm) will not include a centre rail.

6.
Place the end caps on the sprung slats and attach to frame
(centre of the gently curved slats should be upwards).
* Please note - if you have ordered a standard single (90cm) or super-king (180cm) bed base you will
also receive a set of double slats with sliders. These slats are for holes 4-9 from the head of the bed base.
* Some designs (where the mattress doesn’t sit within the frame, but sits on top of it) will come with a
sheet of non-slip matting to prevent the mattress from moving on the base.