Natural Bed Company Orchid User manual

DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP
T: 0114 272 1984 E: [e-mail] www.naturalbedcompany.co.uk
Orchid Four Poster Wooden Bed Assembly Instructions
for Threequarter, Double and King size (120x190,
135x190 and 150x200cm)
Items included in the bed flat pack are:
1 x deep headboard panel 1 x headboard rail
1 x footboard rail 2 x side rails
4 x posts 4 x canopy cross beams
1 x centre rail
1 x set of sprung beech slats
1 x set of plastic end caps (2 per slat)
Fixings: 12x threaded bolts 12x half-moon washers
12x nuts 1x spanner
26x wooden dowels
4x silver bolts 1x hexagon key for silver bolts
1. Place the wooden dowels in the outer holes at the ends of the side
rails, headboard and footboard rails, and the deep headboard
panel. Tap these in securely. (See images to follow)
2. Screw the 12 threaded bolts into the metal insert nuts located on the
four posts (see images to follow).

DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP
T: 0114 272 1984 E: [e-mail] www.naturalbedcompany.co.uk
3. Next build the headboard: take the two posts that have 4 threaded
bolts screwed into them, and attach the deep headboard panel and
corresponding headboard rail (which will be numbered) using the
half-moon washers and nuts provided.
4. Take the remaining two posts and foot rail and match the numbers to
build the footboard in the same way.
5. Attach the side rails to the headboard and footboard posts then
loosely secure using the half-moon washer and the nut with the
spanner provided (see image below). Ensure the frame is square then
fully tighten all of the nuts using the spanner
6. Lower the centre rail onto the brackets and push down firmly into
position –see second image above.
7. Again matching the numbers, place the shorter top cross beams onto
the top of the posts across the bed’s width. (you may need a second
person to hold this in place) Place on top, the long posts along the
length of the bed ie from head to foot. Connect the beams to the
posts using the long silver bolts, and tighten using the hexagon key.

DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP
T: 0114 272 1984 E: [e-mail] www.naturalbedcompany.co.uk
8. Attach the end caps to the sprung slats (see next image): an end-cap
slots on to each end of the slat (ensure the slat curves up in the in the
middle and the ‘peg’ on the end cap points downwards.)
9. Attach the slats to the bed frame by slotting the pegs of the end caps
into the predrilled holes, which run along the upper side of the inner
side rails/centre rail.
If you have any queries about the assembly procedure – please call our
sales team on 0114 2721984, Mon-Sat 10am-5.30pm
We hope you enjoy your Natural Bed Company Bed!
Long beam
Short beam