Natural Bed Company Kyoto Bed withHeadboard User manual

KYOTO COLLECTION
ASSEMBLY INSTRUCTIONS

FITTINGS FOR THE KYOTO COLLECTION
THESE ASSEMBLY
INSTRUCTIONS APPLY TO
THE FOLLOWING MODELS:
• Kyoto Bed, Kyoto Bed with
Headboard
• Kumo Bed, Kumo Bed with
Headboard
• Kobe Bed, Kobe Bed with
Headboard
3 X
NUTS*
3 X
DOME
HEAD
BOLT*
4 X
WASHERS
1 X
ALLEN KEY
3 X
HALF
MOON
WASHER*
1 X
SPANNER
4 X
SCREWS
6 X
FLAT HEAD
BOLT
1.
Place the rails on the legs as
shown, then screw in the flat head
bolts with the allen key.
* 2 IF SINGLE BED
(only additional tool required is a Philips head screwdriver):
* Please note - All timber sections have numbers
pressed into the timber where they are tied together
to indicate how they should be positioned (e.g side
rail hole1 connects to leg rail hole1).
* Please note - Single bed bases will not include a
centre rail

2.
Using the dome headed
bolts connect the headboard
panel to the side/centre rails
- secure with the half moon
washers and nuts. Tighten
with the spanner.
3.
Position the head end panel and foot
end panel - secure using the small
washers and screws provided.
* If you have ordered a bed without a headboard please
ignore this step.

4.
* Please note - if you have ordered a standard single
(90cm) or super-king (180cm) bed base you will also
receive a set of double slats with sliders. These slats
are for holes 4-9 from the head of the bed base.
Place the end caps on the
sprung slats and attach
(centre of the gently curved
slats should be upwards)

THANK YOU FOR BUYING A BED FROM
DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP
T: 0114 272 1984
E: [e-mail]
W: WWW.NATURALBEDCOMPANY.CO.UK