Natural Bed Company Kobe User manual

Natural Bed Company
168-170 Devonshire Street, Sheffield, S3 7SG. T: 0114 272 1984
[email protected] www.naturalbedcompany.co.uk
Assembly Instructions for Kobe, Kumo and Kyoto
Wooden Beds Without Headboards
Superking Size (1.80x2.00m)
Items included in bed flat pack are:
2 x large beams (these are the leg panels)
2 x long slim side rails
1 x slightly shorter centre rail (not included if you have ordered a single bed)
1 x shallow L shape foot-end panel
1 x headboard-end wide slat
1 x set of sprung beech slats
1 x set of double sprung beech slats and sliders
1 x set of plastic end caps (2 per slat)
1 x rubberised non slip mat
Fixings: 6x long bronze bolts with a hexagon key
4x brass screws and washers
The only additional tool you will require is a Philips-head screwdriver.
NB: All timber pieces have numbers pressed into the timber where they are fixed
together.
1. Lay the large beams upright on the floor.
2. Place the long side rails across the beams ensuring that the numbers next to
the holes in the beams match those stamped into the underside of the side
rails. Using the long bronze bolts attach the side rails to the foot beams as
shown below:

Natural Bed Company
168-170 Devonshire Street, Sheffield, S3 7SG. T: 0114 272 1984
[email protected] www.naturalbedcompany.co.uk
3. Do the same with the centre rail as shown on the previous page – the centre
rail will be slightly shorter at the foot-end (this will not be necessary if you
have ordered a single bed where no centre rail is required)
4. Attach the wide slat at the head end as shown above using the brass screws
and washers. Then attach the shallow L shape panel across the foot end of
the bed frame using the remaining brass screws and washers as shown below:
5. Attach the end-caps to the sprung beech slats (see below).
6. Attach the slats to the bed frame as shown below:
7. Ensure the slats are convex (like hills) when placed into the pre-drilled holes.

Natural Bed Company
168-170 Devonshire Street, Sheffield, S3 7SG. T: 0114 272 1984
[email protected] www.naturalbedcompany.co.uk
8. Counting from the headboard end, the third slat will be a double slat (made
up of an upper standard slat to which is attached a lower second slat via a
plastic slider) – see image below. Slats 4-9 will be double slats, the others are
standard single slats (see image below).
9. Once the frame has been completed, place the rubberised non-slip mat in the
middle of the bed to prevent the mattress from sliding.
We hope you enjoy your Natural Bed Company bed!