Natural Bed Company Oregon User manual

DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP
T: 0114 272 1984 E: [e-mail] www.naturalbedcompany.co.uk
Oregon Wooden Bed Assembly Instructions for Single
Size (.90x1.90m)
Items included in the bed flat pack are:
1 x headboard panel
1 x headboard rail (this rail has more holes than the footboard rail)
1 x footboard rail
2 x side rails
1 x centre rail
1 x set of sprung beech slats
1 x set of double sprung beech slats with sliders
1 x set of plastic end caps (2 per slat)
Fixings: 4x threaded bolts 4x half-moon washers
4x nuts 1x spanner
8x wooden dowels
3x dome-headed bolts 1x 5mm hexagon key
1. Screw the four threaded bolts into the side rails (See images to
follow)
2. Insert the wooden dowels into the headboard and footboard rails,
tap these in securely. (See images to follow)
NB. The photos show a larger size bed with a centre rail. This size
doesn’t have a centre rail.

DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP
T: 0114 272 1984 E: [e-mail] www.naturalbedcompany.co.uk
3. Bring the sections together, then secure using the half-moon washer
and the nut with the spanner provided (see images below). NB: the
images below are of the underside of the bed frame. You can tighten
the bolts as shown by lying on the floor or, if there are two of you,
you may find it easier to turn the bed upside-down for this procedure
(in this case please ensure you have something on the floor to protect
the bed frame)
4. Attach the headboard using the dome-headed bolts and the hexagon
key –see image (5) below.
5. Attach the end caps to the sprung slats (see image to follow): an end-
cap slots on to each end of the slat (ensure the slat curves up in the in
the middle and the ‘peg’ on the end cap points downwards)

DEVONSHIRE POINT, 123-125 FITZWILLIAM STREET, SHEFFIELD, S1 4JP
T: 0114 272 1984 E: [e-mail] www.naturalbedcompany.co.uk
6. Attach the slats to the bed frame by slotting the pegs of the end caps
into the predrilled holes, which run along the upper side of the inner
side rails. (See image below).
Counting from the headboard end, the fourth slat will be a double slat
(made up of an upper standard slat to which is attached a lower second slat
via a plastic slider) – see image below. Slats 4-9 will be double slats, the
others are standard single slats.
You can make the ‘feel’ of the slat base firmer by moving the sliders out to
the edges (as shown above). For a softer/more flexible feel move the
sliders towards the centre of the slats.
If you have any queries about the assembly procedure – please call our
sales team on 0114 2721984, Mon-Sat 10am-5.30pm
We hope you enjoy your Natural Bed Company Bed!