7. If attaching to a Headboard –see instructions accompanying Headboard Brackets
GhostBed • 7143 West Broward Blvd • Plantation, FL 33317 • Phone: 855-855-4499
WWW.GHOSTBED.COM Copyright © Nature’s Sleep, LLC 5-1-2020
1. Unfold the side vertical outside supports (A) placing
them approx. 4 feet apart with the hinges facing inward.
Unfold and place the center middle vertical support (B)
in between the 2 supports.
Unfold and place the Horizontal Support (C) at the head
and foot with the hinges facing outward.
2. Align the side vertical support corners with
the horizonal support corners and attached
with 1 screw and nut at the top and 1 at the
bottom by the leg plate. Attached the middle
support with the longest screw thru the hinge
section. Use the enclosed wrenches to tighten.
3. Place the Bundled slat sections (D) in
the middle on each side snapping each
slat end into the plastic seat.
4. Place each of the 16 slats (E) into each of
the seats, snapping each end in place.
5. Unfold and unzip the cover, then place
over the foundation. With an assistant tip
the foundation on its side to zip the cover
closed.
6. If using the legs, screw each leg into the
frame thru the slit in the cover. Make sure to
hand tighten each leg completely.
Thru the unfolded hinge, insert and tighten 1 Screw and nut
