Nature's Sleep GHOSTBED User manual

Patent Pending
Please Note: The Foundation should be assembled on a hard, flat Surface
Be aware of rough or sharp edges, use care during assembly - It is recommended that two people are available for assembly -Please follow steps in order for best results
ALL IN ONE FOUNDATION

7. If attaching to a Headboard – see instructions accompanying Headboard Brackets
GhostBed • 7143 West Broward Blvd • Plantation, FL 33317 • Phone: [phone]
WWW.GHOSTBED.COM Copyright © Nature’s Sleep, LLC 10-1-2020
1. Unfold the side vertical outside supports (A) placing
them approx. 4 feet apart with the hinges facing inward.
Unfold and place the center middle vertical support (B)
in between the 2 supports.
Unfold and place the Horizontal Support (C) at the head
and foot with the hinges facing inward.
3. Place the Bundled slat sections (D) in
the middle on each side snapping each
slat end into the plastic seat.
4. Place each of the 16 slats (E) into each of the
seats, snapping each end in place.
5. Unfold the cover and place it over the foundation.
Pull each corner over the frame, an assistant may be
helpful, until the cover completely and smoothly
covers the foundation.
6. If using the legs, screw each leg into the
frame thru the slit in the cover. Make sure to
hand tighten each leg completely.
Thru the unfolded hinge, insert and tighten 1 Screw and nut
2. Align the middle support with the metal flaps
pointing away from the hinge section and attach using
the longest bolt thru the hinge section, repeat the
same on the opposite side. Align each corner with the
vertical supports and attach using 10 bolts, 1 thru each
support, the other by the leg plate. Tighten all nuts
with the enclosed wrench.