- 7 -
After treatment, please place both electrodes back onto the pro-
tective foil. The electrodes will last longest if stored in a cool place
(a fridge, for example). Adding a few drops of water to the surface
will restore the adhesiveness of the electrodes.
How do I use Nausem?
To switch on and increase the intensity, press the ON/HI key (5).
The level of intensity increases each time you press the key (max.
of 10 levels). The greater the intensity, the “more noticeable” the
current.
To switch off and lower the intensity, press the LO/OFF key (4).
The level of intensity decreases by one level each time you press
the key and the Nausem will switch itself off after level 1.
To select the desired programme, press the MODE key (2). Press
the key to switch between programmes 1 and 2. The selected
programme is shown in display 1or 3. If no level of intensity is
subsequently selected, the Nausem will automatically switch off
after about 20 seconds.
If the Nausem is switched off and then back on again later, the last
programme that was used will be displayed.
After the programme has been changed, the level of intensity will
automatically be reset to the lowest level. Should you wish to
switch off the Nausem during treatment, please press the MODE
key (2) first to allow the level of intensity to re-set automatically to
the lowest level. Once this has occurred, switch off the Nausem by
pressing the LO/OFF key (4).
The Nausem has an automatic timer function. The length of
treatment is approx. 15 minutes after which the Nausem will
automatically switch off. A flashing light in display 1or 3indicates
that the timer function is on. Should the programme be changed
during treatment, the timer will continue to run and will not re-start
at 15 minutes.
When using the Nausem for the first time, you will find that the
default setting is low-frequency stimulation (Programme 1).
