Current as of 2021-01-26
25077
M24D1R205-M28A1R170 HDMI 2.0
Cable (for NA-T3 to use
ith Ninja V housing)
Instruction Manual
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recogni e the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera.
Please read this manual carefully before using the product, this will maximi e
its performance as well as its lifetime.
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use, and exceptionally HDMI and SDI cables are limited to one year. This
warranty only applies to products purchased from authori ed NAUTICAM
dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authori ed
service centre(s). Please note that this warranty only applies when the product
is purchased in the territory where the service centre is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthori ed modifications and/or repairs of our products will automatically
invalidate the warranty.
RECAUTIONS
•Do not place excessive stress on your HDMI cable connector.
•Do not bend or twist your HDMI cable.
DENTIFICATION OF
ARTS
ONNECTING THE CABLE TO THE CAMERA HOUSING
Unscrew M28 accessory port cap
2. Insert the HDMI 2.0 cable through the M28 port
It’s recommended to install the cable first before
installing the camera
3. Gently push the cable into the M28 port opening
of the housing, until it cannot go in any further.
4. Then, tighten the HDMI 2.0 cable by turning the
threaded working ring
