Nauticam 83255 User manual

Update as of 2020-02-28
Instruction Manual for Bayonet Converter
for NA-TG5 / Olympus PT-058/059
PN#83255, #83256
FOREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the
requirements of professional as well as amateur underwater
photographers and fulfill them through the innovative designs of our
products. We strive to achieve a high level of user-friendliness by
allowing stress-free installation and easy operation of all important
functions of the camera.
Please read this manual carefully before using the product, this will
maximize its performance as well as its lifetime.
WARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for
consumer use. This warranty only applies to products purchased from
authorized NAUTICAM dealers and does not extend beyond the original
retail purchaser.
To return your product for service, please contact your regional
authorized service center(s). Please note that this warranty only applies
when the product is purchased in the territory where the service center
is located.
NAUTICAM does not hold responsibility for damage, of any nature, to
any equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the
inability to capture images even if it is due to the malfunctioning of our
products.
Unauthorized modifications and/or repairs of our products will
automatically invalidate the warranty.
Remove the optical fiber connector from housing, then install the
optical fiber connector provided.
Align the 4x positioning blocks on the bayonet converter with the slots
on the front of the housing.
--- continue on next page ---
IDENTIFICATION OF PARTS
INSTALL TO NA-TG5 HOUSING
Bayonet Converter
M52 Locking Ring
Lens Release Button
Lens Alignment Dot
Lens Alignment ‘’I’’ mark
Optical Fiber Connector
Fastening Tool
Hard Cap
Positioning Blocks (4x)
Bayonet Converter
M52 Locking Ring
Lens Alignment Dot
Optical Fiber Connector
Fastening Tool
Hard Cap
Positioning Block
Lens Alignment ‘’I’’ mark
Lens Release Button
Bayonet Converter for Olympus PT-058/059
Bayonet Converter for NA-TG5

Update as of 2020-02-28
--- continued from front page ---
Place the locking ring on the bayonet converter, then fasten the
converter on the front of the housing with the fastening tool provided.
Remove the Olympus optical fiber connector from housing, then install
the optical fiber connector provided.
Align the positioning block on the bayonet converter with the slots on
the front of the housing.
Place the locking ring on the bayonet converter, then fasten the
converter on the front of the housing with the fastening tool provided.
*Attention: Before installing WWL-C into the housing, pre-install the
optical fiber cables as shown in case of using strobes.
Example: WWL-C with bayonet Converter on the NA-TG5 housing.
--- continue on next page ---
INSTALL TO OLYMPUS PT-058/059

Update as of 2020-02-28
--- continued from front page ---
SPECIFICATIONS
PN#
Description
Weight
83255
Bayonet Converter for NA-TG5 (to use with
WWL-1/WWL-C)
125.5g
83256
Bayonet Converter for Olympus PT-
058/059 (to use with WWL-1/WWL-C)
124g
COMPATIBILITY
Compatible
Lenses:
83203 Wet Wide Lens Compact (WWL-C)
83214 Bayonet Mount Adaptor for SMC/CMC
Remark: Nauticam supports only e-manuals. Please download corresponding
product manuals on Nauticam.com website, or contact us for e-manuals.