Nauticam M67 User manual

Current as of 2016-11-04
Instruction Manual for M67/M77 to
Bayonet Mount Converter
PN# 83213, 83215
F
OREWORD
Thank you for your purchase of a NAUTICAM product
At NAUTICAM, we pride ourselves in the ability to recognise the requirements
of professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products We strive to achieve a high
level of user-friendliness by allowing stress-free installation and easy
operation of all important functions of the camera
Please read this manual carefully before using the product, this will maximise
its performance as well as its lifetime
W
ARRANT
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use This warranty only applies to products purchased from authorised
NAUTICAM dealers and does not extend beyond the original retail purchaser
To return your product for service, please contact your regional authorized
service centre(s) Please note that this warranty only applies when the product
is purchased in the territory where the service centre is located
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products
Unauthorised modifications and/or repairs of our products will automatically
invalidate the warranty
I
DENTIFICATION OF
P
ARTS
*There are two alignment pins at the bottom of the holder, by relocating the
two screws to the threaded holes around the holder, the position of the
holder can be changed
#83213 M67 to Bayonet Mount Converter is used as an example in t is
instruction manual, #83215 will be slig tly different in term of appearance.
I
NSTALL TO THE
P
ORT
Align the two positioning pins on the back of the converter with the slots on
the front of the port Fasten the converter on the front of the port with the
tool provided
Note: T e position of t e converter can be adjusted by relocating t e two
positioning pins into t e t readed oles around t e converter.
M
OUNTING
L
ENS
Align the “I” mark on the lens with the “I” mark on the Converter and then
push it in
Turn the lens clockwise until the “I” mark on the lens aligns with the WHITE
dot on the converter and a “click” sound is heard
--- continue on next page ---
Lens release button
Fastening tool
Lens alignment dot
Positioning
pin
s
*
(x2)
Threaded
hole
s
for
positioning pin (6x)
M
6
7
/ M77
thread

Current as of 2016-11-04
--- continued from front page ---
U
N
-
MOUNTING
L
ENS
Press and hold the RED lens release button and then turn the lens anti-
clockwise
Remove the lens when “I” mark on the lens aligns with the “I” mark on the
converter
S
PECIFICATIONS
Mount:
83213: M67 to Nauticam bayonet mount
83215: M77 to Nauticam bayonet mount
Compatible Lenses:
83201
Wet Wide Lens 1 (WWL
-
1)
83214 Bayonet Mount Adaptor for SMC/CMC
Press
and hold