NavAtlas DXB500DVR User manual

DXB500DVR
DXBSOODVR
QUICK
START
GUIDE
This Quick Start Guide gives you the basic information
to start using your
DXB500
DVR. Please call
customer service at 1-844-NAVATLAS, 1-844-628-2852
NavRtlasTM
Customer Service Toll Free: 1-844-628-2852
1

Main Unit Installation
Installation 1:
Installation 2:
~
~~
There aro :ds of lit
length,interchangeable ~
2
M5X60 Six angle screws,
-suitable for fixed round
tube
q>40-q>60
n_ M5X30 Six angle screws,
g suitable for fixed round
tube
q>25-q>40

Camera Installation
Installation 1:
Installation 2:
There are two kinds of
length,interchangeable
ll ll-
M5X60 Six angle screws,
suitable for fixed round
tube
<p40-<p60
M5X30 Six angle screws,
suitable for fixed round
tube
<p25-<p40
NOTE:Using the interchangable brackets, you can position the camera
to suite any position.
3

W irin g Diagram - Inputs/Outputs
Black
1.5M
Heat Shrinkable Sleeve Red
06 PET -022 Braided Sleeve Heat Shrinkable Sleeve
4

Product Specification
LCD: 2.7inch 960x240 RGB HD
2 WAY HD CAMERA
MCU: AMBA A7LA70+B5
SENSOR: IMX322
Camera lens: Hj5010
Video resolution: 1920x1080 30P 16:9 I 1280x720 30P 16:9
Compression format: H.264
Seamless loop recording
NOTE:
The recording time can be set to 1 min, 5 min, 10 min, or Continuous (Continuous
recording will record for 30 min and auto save, then continue until the unit is stopped).
Saved video files will show as 2 files (Front cam and rear cam) on the SD card.
MICRO SD CARD:Use only Class 10 or better SD card, lower quality cards will
result in choppy playback and bad recording.
HDMI OUT:Supports an HDMI connection to an external monitor (Optional).
A/V OUTPUT: Supports an A/V RCA connection to an external monitor (Optional).
USB:USB connection is used to sync/transfer files from the SD card to PC.
WARNING: Do not connect USB cable while the unit is connected to 12V, damage
to the unit may occur.
Indicator Description
Red light: power light, boot
Blue light: record light, flicker
5

Key Description
~
-
F
t-
RST
;
Q
:X:
m
Cl)
::;)
~
::::)
0
::>
CIC
~
I'-
/
9
"'iij]
F=
t-
2])
~
v
"
9
p
~
PLAY/STOP: Short press,start and stop recording
POWER:
Short
press will turn on the unit, long press will turn
off
the unit;
while
recording a
short
press will turn the screen on/off.
M:Short
press will
enter/exit
Menu, long press will
enable/disable
MIC
recording.
DOWN
:Short
press will move
DOWN/LEFT
in Menu, and
decrease;
Long press will switch screen
view
from
split
screen to
front
cam and back.
UP
:Short
press will
move
UP/RIGHT
in Menu, and increase;
Long press will switch screen
view
from split screen to
rear
cam.
S
:Short
press will confirm in Menu,
Long press will switch to
Playback
mode.
Reset: Short press reset button
6

Record Mode
Record Mode
D Have insert TF card
19"20x1 080 30P
Not insert TF card
Record loop overtime(1 min 5min
1Om in continue)
Record light flashing
Record time
Micon
Mic off
Resolution
-
AEbias
2015/11/2714 : 35:15
Current time
7

Playback Mode
long press S enter the playback modes
Playback file list
Short press M can be set play mode (play one/ play all/repeat one /repeat all)
Short press M can be set delete file
Short press S play/pause,long press S return to the menu
8

MENU Instructions
Short press M Enter/ exit menu
Short press S to confirm
Press down up (move down/left and up/right)
Resolution
Set the video resolution
1920*1080P/1280*720P
Recording Time
Set the video time
1min/5min/1
Om
in/continue
Time Setup
Can be set year/month/date/hours/
minutes
Language Setting
Set Language
Can be set English/Chinese/Traditional Chinese/Russian
WDR
Wide dynamic range
Can be set on/off
AE bias
Auto exposure setting
Anti flicker
SetAnti flicker
Can be setAuto/60hz/50hz
Image Quality
Set the image quality
S.Fine/Fine/Normal
9

MENU Instructions
Meter Mode
Set Meter Mode
Can be set Center/Average/Spot
Output Dimension
Can be set Output Dimension
Can be displayed on the screen
Front/Rear/Front+Rear
Display Setting
Can be set LCD brightness /contrast
Auto Backlight Off
Can be set auto backlight off
/1
min/3min/5min
Audio Volume Setting
Can be setAudio Volume output
Beep Sound
Can be set Beep Sound On/Off
Stamp Setting
Set Stamp
Can be set Date/Time/Driver ID
DriveriD Setting
Can set the driveriD
Card Volume
Can display the TF card
of
capacity
usage
Memory Format
Erase the contents
of
the TF card
Default Setting
Restore the default settings
Software Version
Software version number
10

Copyright and Trademark Notes
This product incorporates copyright protection technology that
is protected by method claims of certain U.S.
patents and other intellectual property rights owned by Macrovision Corporation and other rights owners.
Use of this copyright protection technology must
be authorized by Macrovision Corporation, and
is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision
Corporation. Reverse engineering or disassembly is prohibited. Manufactured under license from Dolby
Laboratories. Dolby and the double-D symbol are trademarks
of Dolby Laboratories. DVD Logo is a
trademark
of DVD Format/Logo Licensing Corporation registered in the U.S., Japan and other countries.
SD Logo is a trademark
of SD-3C, LLC. iPod and iPhone are trademarks of Apple Inc., registered in the U.S.
and other countries. Dual Electronics Corporation
is not affiliated with Apple, Inc. Other trademarks and
trade names are those
of their respective owners.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
11

NOTE:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15
of
the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference
in
a residential instailation.This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used
in
accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur
in
a particular installation.
Ifthis equipment does cause harmful interference to radio
or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more
of
the following measures:
( 1 )
Reorient
or
relocate the receiving antenna.
(
2)
Increase the separation between the equipment and receiver.
( 3 ) Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
( 4 ) Consult the dealer
or
an experienced radio/TV technician for
help.
FCC
Radiation
Exposure
Statement
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
FCC
10:MTE/CEC/516071440
12