TL-RGB-CTLR
PINNACLE SERIES
RGB + TUNABLE WHITE LED
CONTROLLER & REMOTE GUIDE
REMOTE TO RECEIVER PAIRING WIRING DIAGRAM
t. 1.514.695.8228 I 1.855.739.8228www.ndrelectric.com
USER GUIDE
Use Match key
1. Match: Short press match key of the receiver, within
5s, press on/off key of the remote 3 times.
2. Delete: Long press match key of the receiver for 5s,
delete all matched remote.
Use Power-up
1. Match: Switch off the power, then switch on power
again, short press on/off key 3 times on the remote
quickly within 5s after power on, the link is done once
the light blinks 3 times.
2. Delete: Switch off the power, then switch on power
again, short press on/off key 5 times on the remote
quickly within 5s after power on, the unlink is done
once the light blinks 5 times.
3 of 3
WW
+
-
+
IN PUT
12-24VD C
Uin=12-24VDC
Iin= 15 .5A
V5-M
RGB+CCT 5CH LED Controller
Uou t=5× ( 1 2-2 4) VD C
Io ut=5× 3 A
Pout =5× ( 36 -72 ) W
Temp R ange : -20℃~+55℃
OUT PU T
W4 +
+
2.4G wir eless controlRoHS
W5
W
0.5-1.5m m2
6-8mm
1. The product shall be installed and serviced by
a qualified person.
2. This product is damp location rated (not waterproof).
Avoid direct exposure with the sun and water.
3. Good heat dissipation will prolong the working life
of the controller, ensure proper ventilation where the
controller will be installed.
4. Check to make sure the output voltage of the
power supply used complies with the working voltage
of the product. Recommended power supply: NDR
LED Class 2 Driver (TLD24V-30W, TLD24V-60W or
TLD24V-96W).
5. Ensure all wire connections and polarities are
correct and secured before turning on the power to
avoid any damages to the LEDs.
6. If a fault occurs, please contact NDR Electric at
1-855-739-8228 or online at ndrelectric.com.
SAFETY INFORMATION
DYNAMIC MODE LIST
No
1
2
3
4
5
6
7
8
9
10
Name
RGB jump
RGB smooth
6 color jump
6 color smooth
Color temperature smooth
RGB fade in and out
Red fade in and out
Green fade in and out
Blue fade in and out
White fade in and out
TROUBLESHOOTING
Malfunctions
No light
Wrong color
Uneven intensity
between front
and rear, with
voltage drop
No response
from the remote
Causes
1. No power
2. Wrong connection or insecure
1. Wrong connection of R/G/B/WW/CW wires
1. Output cable is too long
2. Wire diameter is too small
3. Overload beyond power supply capability
4. Overload beyond controller capability
1. The battery has no power
2. Beyond controllable distance
3. The remote did not properly pair with the controller
Troubleshooting
1. Check the power
2. Check the connection
1. Reconnect R/G/B/WW/CW wires
1. Reduce cable or loop supply
2. Use thicker gauge wire
3. Increase power supply
4. Add power repeater
1. Replace battery
2. Reduce remote distance
3. Re-pair the remote
Power Supply
12-24VDC
Constant Voltage
RGB+CCT LED strip
AC110-230V
