Neptune Technology T-10 User manual

T-10 Meter Assembly Instructions

Chamber Assembly
2
Upper Half
Thrust Roller
Diaphragm
Ball and Disc
Outlet Gasket
**Please note Outlet Gasket will be removed for competition.
Lower Half

Chamber Assembly
3
Thrust Roller
Ball and Disc
Insert thrust roller in the ball and disc.

Chamber Assembly
4
Lower Half
Ball and Disc
Insert ball and disc into lower half.

Chamber Assembly
5
Diaphragm
Lower Half
Insert diaphragm into lower half.

Chamber Assembly
6
Lower Half
Upper Half
Snap upper and lower half together.

Chamber Assembly
7
Outlet Gasket
**Please note Outlet Gasket will be
removed for competition.
Chamber
Insert outlet gasket into chamber.

Meter Assembly
8
Chamber Assembly
Maincase
Place chamber assembly into meter maincase.
Ensure outlet gasket is facing the outlet of the meter.

Meter Assembly
9
Strainer
Maincase
Place strainer into meter maincase as shown above.
Ensure the strainer is fully seated and flush with the
machined surface.

Meter Assembly
10
Liner/Gasket
Meter Outlet
Place liner/gasket into meter maincase.
Ensure liner/gasket dome is facing up away from
meter.

Meter Assembly
11
Bottom Cap
Meter
Place bottom cap on meter maincase.

Meter Assembly
12
Bolts
Meter
Insert bolts into maincase and tighten them with
your finger.

Meter Assembly
13
½” Wrench
Finish tightening bolts with ½” wrench.

Complete Meter Assembly
14
Register
Flip meter over and place register on bayonet.
Secure by turning the register clockwise.